Clean the screen.

I've had the same problem and was able to get rid of the fruit flies using the following method.

First, sprinkle diatomaceous earth on the dirt in the plant pots. Diatomaceous earth is all natural and non-toxic, but it will kill the fruit flies.

Here's a link for killing bugs naturally with diatomaceous earth:
How to Get Rid of Spiders Naturally with Diatomaceous Earth

Next, make a mild soap and water solution, pour it in a spray bottle and spray the plants. Make sure the solution is mild because if it's too strong it will affect the plants.

Here's a link for the homemade insecticide soap recipe:
How to Make Homemade Insecticidal Soap for Plants Today Homeowner

The combination of the diatomaceous earth and insecticide soap will take care of your fruit fly problem. It will probably take about a week or so for all of the fruit flies to die, but if you're vigilant you'll take care of the problem.

First You can try a hard reset: Unplug TV from AC mains and remove all cables from TV. Wait about 30 minutes and replug to AC power and redo the cabling. Switch on the TV and see if it works..


Good luck...

Possibly water is trapped there and the flies are breeding there.

you can clean the fly wheel where the magnets are an see if that helps . you might need a NEW mag.

lickitysplit,

See my tip at http://www.fixya.com/support/r4690955-clean_lense_screen_in_projection_tv which explains the process.

Thanks for using FixYa and for the great rating.

hardrocko

Try unplugging the T.V. for 30 seconds and see if that helps. If you have it connected to a power strip turn the power strip off then back on. If neither of those help then you may have killed the screen. You would either have to buy a new T.V. or have the screen replaced.

removw chop screen and blower housing unplug little wire under mag remove 2 screws and remove mag reverse prosess with new mag but pull mag away from fly wheel and snug screws center magnet on flywheel over legs of magneto place .010 feelre guage inbetween and loosen screws, hold mag against flywheel and tighten remove feeler guage reinstall kill wire on bottom of mag install blower housing and chop screen hope tis helps

Get a technician to clean them out for you, for safety reasons. it is possible - by the way - to clean flies from the LCD except the fact that you must know how to handle such components as a LCD screen disassembled.

hello. it sounds like you have a couple of thing wrong.!!! one there is a bad fly back transformer.!!! that's arking on to part of the mother board.!!! that's the sparking sound you hear.!!! two is that you have a BAD GREEN CTR GUN.!!! THAT MIGHT BE WHERE THE FLY BACK IS ARKING ON.!!! THAT'S WHAT MAKE'S THE SCREEN GREEN.!!! IT'S SHORTING THE GREEN CTR GUN OUT .!!! & WHAT EVER YOU DO .!!!! DO NOT TRY TO SEE WHERE IT SHORTING FROM !!!.THE HIGH VOLTAGE FROM THE FLY BACK TRANSFORMER .!!! IS NO JOKE.!!! IT CAN KILL.!!! OR PUT IN THE HOSPITAL.!!! THIS IS NO JOKE.!!! SO LEAVE IT TO A SERVICE REPAIR MAN.!!! PLEASE .!!!THANK YOU.!!! "GOOD LUCK"

Usually the best way is to remove the top back cover and clean the inside of the screen with a clean, dry cloth, but be careful because the mirror is mounted on the inside of the top back cover.