Dreyer buzzes but will not come on

try unplugging for a couple of minutes and it should reset to factory settings.

Hello,
their are two possiblities causing that

1) while cleaning the lint from the motor a wire accidently got pulled of of the motor switch

2) to me the buzzing when start button is pushed and may or may not start,the motor is bad

When trying the trick to start the motor by hand the door switch also must be pressed in

Gene

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Hi,
The buzzing is a good sign that the motor is bad...

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

try moving the drum by hand is it free?
if it is try starting the dryer while spining the drum

Sounds like you have a motor problem draging and it can't get started I just replaced one same problem.

It has a bad Thermister. you will need to chage it. it is right on top of the blower housing

When start button is pushed there is a buzzing noise but dryer will not start.

My Hotpoint dryer is seven years old and did the exact same thing. When I got over the anger and the thought of spending 4 or 5 hundred dollars to replace it I started messing with it. I finally decided that since it buzzed when I tried to start it there was current there. The only other thing it could be was the drying cycle knob.
I held the start knob and let it buzz while I slowly turned the dryer cycle knob to the right. As I turned through each cycle it would hit "off" and the buzzing would stop and then resume as I moved past the "off " setting. On the third trip around the dryer "started" and has been working since. Maybe something got out of kilter. Apparently the problem was in the knob that controls the drying cycles.

It may be just your timer switch. Look at all the wiring first. The receptacle to the plug, cord and into the back of the dryer.