How do the wires hook up in a bosch\phillips ltc 0829

Call manufacturer for assistance.

https://www.use-ip.co.uk/datasheets/boschNEZ-5230-IRCW4_Installation_Guide.pdf

try service manual, manualslib.com may have what you need.

I know that with the older bosch radio's PB 10-CD there are two internal fuses that 250V 2AMP. You have to remove four allen screws on the front of Bosch powerbox and then remove the four phillips screws one on each side. This will allow front of radio to be pulled out about 5 inches witch will give you enough access to check/change fuses. Fuses are held in place with plastic cover that has one small phillips screw holding it in place. Hope this helps

Free PDF Manual at the link below with wiring diagrams.

http://www.selectsecurity.net/admin/Installation/KTD-inst.pdf


Please leave rating.

Cheers

Andy

Try hooking it up to another (working) electrical outlet. If that doesn't work, there's several possible problems.

The most likely is that the box was fried when a larger-than-usual current traveled down the line (or even down the coax if lightning struck and your system isn't adequately grounded); the electrical outlet is either pushing too much or too little power; or your house's ground polarity is reversed.

More than likely your box is bad. If you don't know very much about electrical systems, don't go messing with your ground or any outlets without a wall plate.

Hello, A common accurance for dishwasher's that all of a sudden goes dead is a poor installation and consiquently a loose/burnt connection at the junction box. It is located behind the kick plate to you right. ** TURN THE BREAKER OFF BEFORE PERFORMING ANY SERVICE PLEASE ** Remove the wire murret's and inspect the wires condition. (it may be obvious upon inspection) strip them back a bit and twist some new connector's on the wires. That should do it...unless it's a bad timer comtrol or on/off switch, but that would be out of the ordinary for Bosch. Hope that help's. If you've found this info here at fixya to be useful please remember to rate it before you leave. Let me know if I can assist you further. Thank you and good luck. Macmarkus :)

Click on this link http://www.usbi.co.kr/files/cdrom_jumper0-2.jpg to know more about jumpers and how they look...

pelco cctv ptz doec not moving can you give me a solution?thanks a lot.

Hi krajesh52,
Have you tried with in finding any fault in the electronics PCB.

Ananth