Repairing touch panel membranes

F1 Defective Touch Pad or Membrane Replace Touch Pad or Membrane

Tip: Get a hot dish towel and rub that hot towel onto the keypad to free up that sticky keypad before ordering anything.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

JENN-AIR
'Newer Style' Range/Stove/Oven Fault Codes Failure
Code Condition Check/Repair F1 Power to element relay energized during time of day display Wiring harness shorted or change power relay board (PRB)

Note: for double ovens, change second oven board

JENN AIR
Range/Stove/Oven Fault Codes Failure
Code Condition Check/Repair F1 Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)

F1 code means.

Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)

Follow this link to order your replacement part. Good Luck

http://www.appliancepartspros.com/part_details.aspx?part_id=4088611

Hi
I have found the codes you are looking for.I hope this get you in the right track. Let me know how it goes.
F1 Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)
F8 Analog/Digital supervisory Replace clock assembly (also called the ERC)Thank you for writing to fix ya.
Best regards richard

Hello there:
Here is the 2 most common f1 codes for this oven and what the problem is and what repair procedures that should be taken
F1 Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad) F1 Watchdog on board Replace touch pad or clock assembly (also called the ERC)

Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)
if you are handy you can remove control board ribbon clean in and replace..

sounds like more than switch issue probably main circuit board!!!! :) have you tried jenn aire support?

F1 defective touch pad or membrane. 1. replace touch pad or membrane ( this problem is usually the touch pad).
or
F! watchdog on board. 1. replace touch pad or clock assembly (also called the ERC).

Maytag-Maycop-Magic Chef-Jennair-Admiral
Oven Fault Codes:
F0 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock
F1 Defective Touch Pad or Membrane Replace Touch Pad or Membrane
F2 Oven over heat defective Relay Board or (if present) or defective Sensor
F3 Oven Sensor Open Replace Sensor
F4 Shorted wire or Sensor locate short and correct it or replace Sensor
F5 Hardware, safety circuits disagree Replace Clock
F6 Missing AC (power) signal Check for proper voltage (plug, breaker, etc.)
F7 Function key shorted or stuck button Clean and unstick button or replace Touch Pad or Clock
F8 A/D Warning Replace Clock
F9 Door Lock Warning Check door lock circuit or Replace Clock