Is there a WiFi card that works with the e405?

depends Henry is the USA Keurig Coffee Maker rated at 120 Volts AC and did you plug it in to say as an example 240 Volts AC ?
Did a lot of smoke come out of unit if this is the guessed case ?

remove the wifi drivers reboot the system then install it ,

You need a new one, the batteries only last a couple of years.

If you chose the "dough" program it won't get hot at all. If you chose the other programs and it never got hot then you do have a problem. Please advise which program you chose and we'll go from there.

well it can only be 2 things,
the card is bad, and the do go bad.
or the drivers are wrong
why not find the true name if the card, on the card
the using HP.COm use the correct driver for that card.
HP can uses 2 or 3 different cards, some have blutooth.
its not just one offered.

this LP is old, its seems its got XP on it,? the virus magnet.
why not get a newer LP say year 2010 and newer with W7 or newer
so you get both HP and MS support.
ze2000 tells us nothing much sorry
that is not a product number.
this info here is the only why to get the correct drivers
there IS NO OTHER WAY,
go to hp.com they ask you then same thing,
do so.,
one trick if say there are 3 wifi drivers, for say XP and only on your exact machine at HP.com
then run all 3 drivers, 2 will fail, and 1 will not.
this is an HP secret, saves pulling card out and reading its words.


but after talking to HP
its no longer supported, its over 12 years old,

its listed on RETIRED page, (MEANS END OF LIFE)
http://support.hp.com/us-en/retired-products

Hi,

If happens you already replace the card and still doing same thing, It only means that the slot for the card is faulty, Its already a motherboard problem. But try updating the BIOS and see if its going to fix the problem, if not its the motherboard that have a problem.

Makecertain that your wiring is not exposed to anything. Be sure to turn the power off to the dryerand check the outlet. Also check to seeif your dryer cord is connected to the dryer right. Usually the outer prongs on the dryer are thehot and in the inner one is the ground.

You try to boot the system with the in-built VGA card and not with your graphics card,then if any problem exist cotact me at my e-mail id : [email protected]

Ofcourse I can help you.

Hi There

you need to format the SD card using any card reader and only then you will be able to use your SD Card in your PDA.

All the Best.

Was this solution helpful? Show your Appreciation by rating it: