Kenmore Elite quiet pak 4

Diagnostic mode for Kenmore Elite He3t model 110 42926 ...

iFixit https://www.ifixit.com > Answers > View > Diagnostic...
Apr 8, 2016 - With the washer empty, close the door. · Push "control/on" or "Start" · Select "Drain/Spin" · Select "No Spin" by pressing SPIN SPEED touchpad.
3 answers · 2 votes: I believe this is very similar to the model I have. Here is what I did to run a diagnostic. ...
F11 error code during Diagnostic test? - Kenmore ...
1 answer
Jan 18, 2016
SOLVED: F11 code error on Kenmore HE3 - iFixit
16 answers
Mar 3, 2011
SOLVED: f h error code - Kenmore Elite HE3 ...
9 answers
Feb 21, 2012
It seems like the washer has no power - Kenmore Elite ...
6 answers
Nov 2, 2017
More results from www.ifixit.com

Diagnostic Test; Starting The Test Mode; Test Program ...

ManualsLib https://www.manualslib.com > ... > User manual
Close the door. Select the DRAIN/SPIN cycle. Select NO SPIN by pressing the SPIN SELECT button five (5) times. Push Prewash Option button four (4)times within ...

..

Spinning is prevented when the cover is open. Possibly a broken "door closed" switch is or its wires are broken. Lift the lid platform and check the switch. May be just debris preventing it from engaging. Remember, the lid and the close switch must be engaged before the control circuit will allow the high speed spin from happening. This is an essential safety feature and should never be circumvented. A high speed drum can literally pull an arm from its socket if caught so make sure it's working properly

Press and hold "end of cycle" at the right end of your panel for 3 - 5 seconds. The machine power should be on.
Try the door 2 minutes after this.

My Kenmore Elite dryer keeps beeping..just going through the end of cycle alarm-high,low,off...anyone have any suggestions?

my kenmore washer elite11 leaks water in the rinse cycle on the floor.

the lock switch is probably stuck. make sure machine is off but plugged in still. Push in on the door while gently giving a couple of thumps around the lock area and the lock will probably "click" open.

this is joyce
what kind of waher have you got? model #

Set it toward the end of any cycle - it will sense the water level and pump it out before moving on.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Now this is a drain issue from the pump, clean out or check drain hose position to make sure hose isnt in water. Front loader right? kick panel under door has two screws, 1/4 or Torx T20 will remove them. You will see a clean out screw handle that holds junk. Use a trash bag wrapped around the clean out to catch water and debris..

Our washer is flashing a F21 and it never finishes the load there is always water left.. what can we do to fix it?