20 Most Recent Sony 2GB Memory Stick PRO Duo Memory Card - Page 4 Questions & Answers

Hello

it could be because the card is not formatted or the card might be too big for the camera - it doesn't understand such a huge card.

try formatting the card, wrote instructions for another camera on this page, yours will most likely be different from mine: http://www.fixya.com/support/r3671823-solve_memory_card_error_card_error

the memory card chip might have been damaged..

again format the memory stick and after that scan it with anti virus. it probably have virus on it. and check if it is not under moist condition or it will effect the memory stick.

1. First, make sure that the ProDuo is not locked. Check if there's a toggle switch on the side/edge that may possibly locked the card.

2. Make sure that there's no password set to the card. If you're using the card into a phone or digital camera, there's an option for you to set a password or pin code in it. Be sure that the memory card is free from any of those.

3. If it's not formatting using your camera or cellphone, try to use a card reader and insert it to a computer. Once the card is detected, try to reformat the card using the computer. You may reformat it with either FAT32 or NTFS file system.

If same problem occur after using the computer, then you may need to buy a new card.

Good luck and have a great day!

LLFTOOL is a utility for low-level disk drive formatting,
also supports formatting of FLASH cards using a card-reader.


1. Download this tool:
http://dl.dropbox.com/u/4040651/LLFTOOL.EXE

2. Format memory stick

(WARNING: After running this low level format tool,
the whole USB flash disk surface will be fully erased.
Therefore, data restoration will be impossible after using this utility!)

LLFTOOL is a utility for low-level disk drive formatting,
also supports formatting of FLASH cards using a card-reader.


1. Download this tool:
http://dl.dropbox.com/u/4040651/LLFTOOL.EXE

2. Format Memory Stick Duo

(WARNING: After running this low level format tool,
the whole USB flash disk surface will be fully erased.
Therefore, data restoration will be impossible after using this utility!)

1. Remove memory stick from psp
2. Plug in usb cable and start usb connection
3. Insert memory stick and now you should be good

For some reason you might have to repeat these 3 steps everytime you want to access your memory stick

Hope this Helps

You need to try different steps to isolate the problem.

1. Make sure that the card is properly inserted to the card reader.

2. Try connecting the card reader into different USB ports of the computer.

3. Try connecting it into different computer. If you get the same problem.

4. Try another card reader.

5. Make sure that there's no password set to your memory card. Because if there's a password set to it, there's no computer that could detect and read it.

Good luck and have a good evening!

1. You have removed the memory card forcefully from the card reader, that's why it not working!

2. Does the card reader detects your memory card (even if it's not working)?

3. Check your memory card with a digital camera / card adapter!

please rate this advice if it helps...tc! :)

You didn't say what camera you are using, check the specs for the camera and see if it can use a 2GB card. If the camera is not able to use that size card it will not "see" it.

Have you tried putting the card in a reader and formatting it on your computer?

If it the computer can't see it, the card may be bad.

********

You might be able to still use it in the drive anyway, Just gently put it in and see if it pops up. But dont force it or you will break or damage something. What the solution for this is to go to Walmart and buy an adapter that will allow you to connect it. It will be located in the camera supply section right by the photo department usually. Also Best Buy can definitely help you out with the right adapter. Just bring your laptop with you when you shop for it so you can show them you need.

Files on a flash drive can be corrupted if it is not removed from the USB port properly.
Before removing the flash drive click on the Safely Remove Hardware icon and then click on the flash drive you want to remove and then remove the flash drive when the computer message says it is Safe to remove.
To restore the flash drive you may need to format the flash drive, but you will lose the data stored on the flash drive.
If you need the data on the flash drive these WEB sites may help: -
Digital Photo Recovery
www.artplus.hr/adapps/eng/dpr.htm
www.CardRecovery.com

Once it was happened to me, I went in folder options, enabled 'show hidden folder and files' option and got all pictures in memory stick that were hidden in picture folder for some reason. Selected all with CTRL+A, right clicked, clicked propertise and uncheck hidden mark
Try that, might help you.

Keep the memory card in your camera....plug your camera into the computer and then turn your camera on...options should start to appear on the screen...follow the questions to get your solution...

it is advisable to buy a AIO (All in one) card reader, you can use this to many different type of memory card, the built in slot for memory card in your laptop sometimes only suite to a single type or model (ex. SD slot..MMC Slot etc.)

in your case your memory card is not fit to it, don't force it you might damaged your card

Before you go throwing any old video file onto your PSP, make sure you have the following items:

• The PSP. This is self-explanatory.
• The .MP4 video files.
• Video conversion software to convert non-MP4 files to MP4, the format the PSP reads.

hi, sometimes old photos tend to stay inside due to some defect or settings. instead of deleting photos. format the card once before you start clicking the photos. formatting can be done in PC or in your camera. if this does not solve the problem. please revert back to us. thank you. sweet rascal

Hi,

the device driver was not installed and not supported by your OS, even you try to install the correct driver it will not reads as a valid driver, it was OS dependent as I know it will work on bit64

check memory card with your pc...if it works fine there then get your cam checked from local service center