Dirt Devil M085850 Featherlite Bagless Upright VacuumVacuum - Answered Questions & Fixed issues
Hi...everytime I turn on my
This is most likely a clogged inlet, clogged hose, or a clogged filter. Just need to inspect it thoroughly and give it a good cleaning.
More info, let me know.
Charlie
2/8/2011 12:28:21 AM •
Dirt Devil...
•
Answered
on Feb 08, 2011
•
390 views
No suction in the head
Open the collection area and behind the bag you will find a filter, this needs to be cleaned and that should solve the problem
3/24/2010 1:48:13 PM •
Dirt Devil...
•
Answered
on Mar 24, 2010
•
95 views
I cant get the power brush to work
can you turn the brush by hand? if it turns real freely the belt is broke or the brush siezed up make sure there isn't any carpet strans wrapped around the ends of the brush otherwise the brush won't turn.if its the belt make sure you clean the motor shaft before you put on the new belt,the old rubber from the old belt will make the new belt run unevevly and break again..good luck
4/8/2009 2:03:10 AM •
Dirt Devil...
•
Answered
on Apr 08, 2009
•
1,135 views
Belt smells burnt
If the belt has melted then there's something obstructing between the brush, belt and dust channel. Check that the endof the brush roll is completely clean, check that the brush roll rolls easily with your hand (obviously don't plug it in or switch it on when repairing/inspecting) If you can locate the motor shaft pin make sure that it rolls easily - if not then the motor may have seized up which will need professional repair. Also check that the filters are clean and the hoses are clear.
3/29/2011 1:35:39 PM •
Dirt Devil...
•
Answered
on Mar 29, 2011
•
970 views
What is the filter bag number
type G
look on amazon or copy and paste
https://www.amazon.com/dirt-devil-model-103-bags/s?k=dirt+devil+model+103+bags
11/28/2022 6:00:41 PM •
Dirt Devil...
•
Answered
on Nov 28, 2022
•
83 views
Dirt devil power stick lite edge to edge
See picture for details. It is unnecessary to remove the roller brush to clean it. The picture will show you how to do but not all vacuum cleaners will have a line where to cut. In this case, you can still use a utility knife just be more cautious where your cutting and not too deep. Make your cuts on both sides of the roller.
If you still need to pullout the roller brush, don’t worry too much about pulling it out strait. Pull one end slightly, do the other end in the same way until it comes out.
10/31/2021 7:39:48 AM •
Dirt Devil...
•
Answered
on Oct 31, 2021
•
127 views
Not finding what you are looking for?