20 Most Recent
Maytag 25.6 cu. ft. Wide-By-Side Refrigerator with PuriClean II Ice and Water - Page 3 Questions & Answers
When water dispenser is pushed the water supply
Our water dispenser will work for about half a glass then the pressure immediately stops and the water flow goes to a small stream. Maytag MDZ2667HES Wide by Side. HELP! Filter was changed approx 3 months ago.
I have a wide by
Probably a bad damper motor that opens and closes to allow more or less cold air into the refrigerator.
How do I reset the
read the box that the filter came in,it tells you on the box,some of them are different,try pushing in the lock and light buttons for like 5 seconds together,on older maytags press the lock and water buttons.you have to perge the filter,keep filling up a cup of water until all the air is out and the water runs steady,if you see it skip there's still air in the line,you might have to fill 6 to 8 glasses to clear out all the air out of the lines
The ice maker is not
Make sure there is a water supply. If the water kit was installed make sure the valve is on where it taps into your cold water line. Check if there is unfrozen water in the part where there are 8-10 plastic fingers or tabs. If there is no water there will never be any ice. It should always be full of either ice or water. It is also possible the valve where the plastic tube enters the back of fridge has stopped working but that is very unlikely. If you have never had the ice working then there is an electric plug for the valve control near where the water tube conects behind the cardboard. It only fits on one way but may need to be connected.
Water does not come from
Hi and welcome to FixYa, I am Kelly. Since you did not include your model number I have to respond in GENERIC terms. Open the freezer door and locate the light switch. Depress the light switch to make sure that the light is going off when the freezer door is closed. This light switch (with plunger) also turns off power to the water in door and the ice maker when the door is open. If the light stays on with the switch depressed it will not make ice or pass water through the door. The switch is removed by sliding a putty knife or thin knife blade on on side of the switch to release the locking tab. The switch will have 3 wires on it. C = (common / power) NC = ice maker and NC = light. There will only be continuity between C and either NO or NC depending on the plunger / actuator position. It will never read between all 3 contacts at the same time but C will always be one of the 2 test points. A replacement light / door switch is less than $10.00.
If you want more specific information or need further troubleshooting assistance after checking the door switch, please respond with your model number and I will gladly help you.
Thanks for choosing FixYa,
Kelly
Refridge would cycle on, fan would come on relay
you were lucky . compressor must run with fan or it will get too hot . if comp is running to hot it will not come on and the fan will . . do you have the cardboard back on frig . this helps direct air to cool comp .. reck the wire connections . and last you may have to take a power ( amp ) reading . the compressor may be bad .. mm.. ps do not run on ext cord and make sure the power at wall plug is good power ...
My refrigerator and freezer just
Hi,
Yes....something is sticking or not starting...
Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing then checkout the last two tips.
If your refrigerator is running but warm, then...
Check out this tip that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...
Refrigerator
Condenser Coil Cleaning Refrigerator Repair
Refrigerator Troubleshooting Refrigerator Compressor
Refrigerator Compressor Start Capacitor and Start Relay
heatman101
Not finding what you are looking for?