20 Most Recent
Hotpoint Aquarius WF000 Front Load Washer - Page 2 Questions & Answers
Leak from front
You take off the top to get into the machine, there are usually screws at rear top holding top panel on.
That said the most likely culprit is the pump which you get to from underneath, followed by the door seal, which you should inspect carefully for very small holes. My guess is the pump, have you checked the filter is clear?
5/16/2014 9:12:24 PM •
Hotpoint...
•
Answered
on May 16, 2014
Maytag Washer Not Completely Rinsing
If your washer has an extra rinse button try pushing it. My Maytag refuses to wash unless that button is pushed, so in your case it may not be completing the rinse cycle correctly.
Just a suggestion.
4/16/2014 4:10:25 PM •
Hotpoint...
•
Answered
on Apr 16, 2014
Hotpoint wf740 aquarius 1400 v noisy banging during spin = dust
It could be a broken drum restraint spring, or a worn or broken. or loose shock absorber.
To check the springs, remove the top cover, and you will see the springs.
Another possibility is the concrete weight could be broken or loose.
You need to remove the lower rear panel of washer to check the shockers and concrete weight.
Please rate my solution.
Thankyou.
4/3/2014 11:44:35 AM •
Hotpoint...
•
Answered
on Apr 03, 2014
Water not pumping out of machine-zanusi aquarius wf000
1. Check that the water tube is properly fixed
2. The tap is on
3. The program is on
If you hear a humm sound without water means that the valve is open but is closed before that.
If no humm is heard then the valve could be broken.
4/3/2014 7:18:47 AM •
Hotpoint...
•
Answered
on Apr 03, 2014
How do you change brushes on a hotpoint aquarius
I have a Hotpoint Aquarius WF740. This does have brushes. Tilt the washing machine backwards & look underneath. The brushes can be seen on the motor housing, they are secured by two screws each.
3/31/2014 2:38:26 PM •
Hotpoint...
•
Answered
on Mar 31, 2014
Aquarius wf541. Am trying to unscrew and remove
There must be something stuck in the filter, as normally it should pull straight out once you have unscrewed it.
Try screwing and unscrewing it at the same time keep twisting and pulling at the filter.
If you can't tremove it, then you sre going to have to remove the complete pump in order to clear the obstruction
Hope this helps you ..
3/22/2014 8:46:57 PM •
Hotpoint...
•
Answered
on Mar 22, 2014
Wf541 problems
if you mean the mains switch power this is available to buy on its own fairly easy to do,only four wires are connected to it.
11/7/2013 8:29:00 AM •
Hotpoint...
•
Answered
on Nov 07, 2013
Not finding what you are looking for?