20 Most Recent
RTO Safety Vacuum Release System - SR-500 Stingl Switch - Page 9 Questions & Answers
How do I access & clear debris in Backwash Restrictor in a Culligan Mark 80 Water Softener?
How to Troubleshoot a Culligan Water Softener
- Check the power supply cord if the unit is not operating. ...
- Check the circuit breakers or fuse box if the unit is not receiving power. ...
- Reset the timer if the house experienced a power failure. ...
- Check the bypass valves to make sure they are in the correct positions.
https://www.hunker.com/12333201/how-to-troubleshoot-a-culligan-water-softener
11/28/2021 4:55:15 AM •
Pool & Spa
•
Answered
on Nov 28, 2021
Mspa lite hot tub control panel comes up with E1 fault
we had the E1 error on our mspa after a water change. solution was a reset for us. plug in power, briefly press test and wait 10 seconds. unplug the power and wait for 10 seconds. plug in the power again and wait 10 seconds after which the reset button is pressed. then press the temperature button on the controller and briefly switch the air button on and off. after this the thermostat did it again. we were relieved that this worked, we had already searched the whole internet. this solution was copied from a model of lay-z
10/8/2021 1:40:28 PM •
Pool & Spa
•
Answered
on Oct 08, 2021
Mspa camaro not heating up properly
Hi I have an Mspa Camaro P-CA090/069 I had an E1 Error code which I have sorted I believe it was the filter, but I'm finding the tub is struggling to heat up it was 26.5 and after 24 hrs it's only 28.5
I would be very grateful if someone can help me with this problem.
Thanks
10/5/2021 4:55:03 PM •
Pool & Spa
•
Answered
on Oct 05, 2021
Removing the impeller on an AP220 Homelite Pump
That impeller is obsolete. It is woodruff keyed to that shaft, IF it is not plastic you can use a jaw set of gear pullers. If it is plastic you many need a bearing puller and a gear puller.
9/5/2021 2:21:50 AM •
Pool & Spa
•
Answered
on Sep 05, 2021
Not finding what you are looking for?