20 Most Recent
Nextar M3 Car GPS Receiver - Page 6 Questions & Answers
1 Answer
Q 4 series GPS has
this seam like a memory failure to me ..and it is the equivalent of a blue screen on computers..Note that these kinda gps have a reset hole with a hidden button ..and you can default it if you press it with a stylus or a sharp object ...if after that is still the same ..you have to reload the software for the program it causes issues..(probably to get the firmware updates..)
Here is the site for support
http://www.nextar.com/frontend/gps_navigation_systems.asp?MODEL=MN2607
Nextar GPS
|
Answered
on Jan 07, 2011
2 Answers
I can not pick up
Hello,
There are to reasons for this; 1. it's either the antenna of your GPS has loosed contact or defective and 2. Maybe the area you are at that particular point in time does not have a good reception.
So check/consider the above two mentioned.
Also, you can also reset the GPS as this might solve the problem. To reset; Unplug the power supply cord from the unit. Unplug the power supply cord from the outlet. Reinsert the plug after five seconds. Insert the power supply cord into the DV 5V input jack on the right hand side of the GPS unit. Resume use of the Nextar GPS and the reset has been completed.
Good luck.
Nextar GPS
|
Answered
on Dec 23, 2010
1 Answer
Can you re~programe a nextar
Because the Nextar has built in maps this does make it extremely difficult to change. When these devices were brought out the company wanted them to stay fixed to one location and they did this by permanently writing the map data to eprom. There are ways you can "modify" your device however this is not legal unless you own the original software that is used to "modify" the device. It is also risky as you can render your device unusable if things go wrong.
Sorry that I cannot be of more help but this is just one of those quirky little devices that the company really didn't want being used outside of its map area.
Thank you for using FixYa
Nextar GPS
|
Answered
on Nov 06, 2010
1 Answer
Hgps35 missing or cooupted mapdata
First, press the "Reset" button or push the stylus into the "Reset" hole, to see if the navigation software can load successfully. If the program still does not load, then the software may be corrupted. Also, if the internal memory fails to read or write and the software cannot load properly, it may be caused by hardware failure. In either case, please return the unit for exchange or repair to the retail location from which you purchased it, or contact us for further assistance.
Nextar GPS
|
Answered
on Oct 05, 2010
1 Answer
Lost the sd card
In that case just buy a new one - you didn't said the exact model so for a better compatibility use one that is 2 GB or smaller. Then all you have to do is to put it in your unit to be configured by it and it's as good as new.
Nextar GPS
|
Answered
on Sep 11, 2010
1 Answer
I can not unfreeze my
Since the operating system and navigation software are preloaded into
the internal flash memory of the GPS, the freezing may either be
software or hardware failure. First, press the "Reset" button or push
the stylus into the "Reset" hole, to see if the navigation software can
load successfully. If the program still does not load, then the
software may be corrupted. Also, if the internal memory fails to read
or write and the software cannot load properly, it may be caused by
hardware failure. In either case, please return the unit for exchange
or repair to the retail location from which you purchased it, or
contact us for further
Nextar GPS
|
Answered
on Aug 29, 2010
Not finding what you are looking for?
