Question about Brother MFC Office Equipment & Supplies
...cartridge with the photodrum unit in it, if the waste toner sensor senses an accumulated waste toner in the cartridge, same error will appear, replace the whole drum cartridge. Hope this helps
Question about Brother MFC Office Equipment & Supplies
sensor. A burst of canned air can fix the problem. Just pull out the toner, open all of the covers and spray air into all the little crevices. You might want to do this outside, in case toner is loose
Question about Brother MFC Office Equipment & Supplies
...toner detect sensor left front upper inside of printer, when a new toner is put in reset lever on cart hits sensor then fall back to front of cart, remove gear asst and put lever in new position, 3/4 ...
...toner trays. You will see the green OPC and the sensor is located in the left upper corner. Also open the top cover and remove the OPC. Clean the sensor with a soft bristle brush. Also make sure the ...
Toner Error - reinstall drum unit I don't know whether the drum unit is bad or not. We have replaced the drum and still get the same error message. Our building was struck by lightning, and I'm ...
Question about Brother MFC Office Equipment & Supplies
...sensor after installing a new toner cartridge follow these steps. 1. With unit powered On, open the front cover. 2. Press the “Options” key. Display will show “Replace Drum?” 3. Press “Start” key. 4. ...
Question about Brother MFC Office Equipment & Supplies
...to fix it? Open the front cover and remove the drum and toner. There should be a paperjam in the machine. It reads back cover open because the piece of paper is covering the sensor for the back
Question about Brother MFC Office Equipment & Supplies
...error 72 on the brother MFC 9700. this code say that Cannot detect Beam Detect signal u should call an engineer or if u wish to try ur self try replace the toner and drum. verifie cables were pluged ...
...paper. 5. Reinstall the drum and toner. 6. Make sure to close the front and back covers. 7. Turn the power back on. If the message stays after all this, there may be a sensor not working. Thanks, ...
Question about Brother MFC Office Equipment & Supplies
...paper motion with optical sensors. A little dust or toner powder in the optical path can cause a paper jam error. You should call a printer tech for deep cleaning and sensor
152 questions posted
Usually answered in minutes!
1,135 Questions
1,012 Questions
743 Questions
623 Questions
406 Questions
