...pulley spins and the belt stays stationary. Any brilliant ideas? Is it possible that there's just some residue from old belt that needs to burn off? Or perhaps the pulley is shot? I did notice that ...
...spin and it smells like it is burning it is only 3 yrs old The burning you smell is probably the belt slipping. There is a belt which is attached to pulleys. The belt engages to spin the basin in ...
...pulley engaging the belt and holding it tight? 2. Is the belt worn out? The belt would be most likely to me. If it is old or obviously worn, replace it. Once the belt is on the drum, motor and ...
belt and rotate the drum pulley CCW. The pulley should push the thrust bearing upwards, releasing the brake, and engage the transmission. If it doesn't you have a bad thrust bearing. It comes as a set
...engage immedietly to check which it is,is not to complicated,pull the washer out some from the wall and tilt it back so the control panel is resting on the wall and the bottom frame has been raised ...
...belt turn the pulley, but the height of the pulley is worn out so it didn't push up a mechanism to release the brake and to engage with the clutch to make the spin. You have to takethe shaft out to ...
...belt while you are tightening the tension bolt. 5.Set the front panel back into the "J" tab at the bottom of the Maytag Neptune.Line the top of the front panel to the side attaching holes and secure ...
...pulley. If the belt is not off, it may be a loose wire to the sensor that switches the dryer off when the belt is off or broken. Mine had that problem. If that doesn't work you will ...
pulley will swivel, allowing the belt to be tightened to the proper tension. You can use a lever to put tension on the belt when retightening the adjustment bolt, but be careful not to overtighten the
belt/pulley - if the belt has been slipping it will polish the pulleys and this will reduce the friction necessary to drive the machine. To fix this the belt should be replaced and the pulley surfaces
855 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
658 Questions
476 Questions