Maytag PAV2300 Top Load Washer "auger" Questions

...s not the entire agitator that's the problem. The agitator base is still fixed & fine, it's the auger section that is loose. Looking at the system, it appears that there are tabs that hold the ...

...any help would be helpful thanks ok you got it perfect,,take that 1/2 in bolt out pull up on top auger and replace the agitator dogs,,,now hold the top part the auger in your hand and push cam

Maytag LAT2301AAE Washer: The auger separates from the agitator. The auger then "floats" and does don't agitate back and forth. It appears the "teeth" inside the auger are worn out

maytag washer model PAV3300AWW The auger slips up on the post and does not rotate properly. Ca the post be purchased seperately from the auger or must it be purchased as an assembly? Go to ...

...to remove that have in bolt..remember the agitator has 2 parts,,now the top piece is called the auger,,and the bottom piece with the paddles is the agitator..pull up from the auger mostly you

...washer has a split design. The lower portion is the agitator, while the upper portion is called the auger. Under the auger is a cam drive. The cam acts as a clutching mechanism that drives the auger ...

...I've got the same problem. The diagram is a bit deceiving because it appears to show the agitator/auger as one piece. However, the bolt only holds the agitator (lower portion) and then the auger ...

...on Whirlpool manufactured washers usually have a split design. The upper portion is known as the "auger", the lower portion is the agitator. To get the whole assembly apart just follow these steps: ...

auger pops off the plastic auger pop off and i pushed it back down buy it keeps popping off what can i do Tighten agitator retaining mechanism. Loose agitator causes cap to fly off.

aggetator not moving during wash cycle, why Does the agitator have an auger at the top, if so you will need to replace the agitator dogs in the auger section. Part #80040 If no auger is present you ...