draw out give it a really good wash in hot soapy water, the compartment where the softener goes normally as a piece of plastic that lifts up so you can clean the compartment throughly. Whilst the draw
...push down on clip and pull draw out. after this you can clean out all the draw and where the softener compartment is it should come apart. to put draw back in just slot it back in. Hope this
...softener particles. What's the problem? take the soap draw out there should b a sign on the draw to press also the top of the sofner compartment comes off u will see a hole where the water goes make ...
...softener being taken from the draw of washing machine You need to remove the complete draw, and take every part out, and thoroughly clean all parts, particularly the syphon tube in the conditioner ...
...draw from tray. Have cleaned thoroughly The Solution: Top up the softener tray with extra water so that it is up to the 'max level' mark. The softener tray works by a siphon action. Thus, the reason ...
...Try thinning softner with water. Take draw out and apart. Clean the softener 'tubes'. The compartment uses capillary action to dispense the softener. If there is any build up, it will not
Question about Bosch Washing Machines
...draw and wash it all out. The most likely cause is that fabric softener has congealed and blocked the dispenser. I hate what softeners do to machines with a vengeance. I would never put any fabric ...
Question about Whirlpool Washing Machines
...side of the softener dispenser. Once water flows through, clean the rest of the draw and where the draw fits and pop it back in and you should be good to go. Keep it clean, say once every few
...softener in from the draw. i have cleaned the draw out nad tested the draw over the sink. it seems to work ok but once its back in the machine the softener does not go into the wash. not sure if ...
34 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions