No fabric softener being taken from the draw of washing machine

Remove the dispenser draw and wash it all out. The most likely cause is that fabric softener has congealed and blocked the dispenser. I hate what softeners do to machines with a vengeance. I would never put any fabric softener anywhere near my machine ever. They cause many problems that are not easily remedied.

Regards

John

I had the same problem, machine not taking fabric conditioner.
So removed top of machine 2 screws and with a bit of wiggling dispenser drawer whilst holding down the drum easily slipped out after undoing a few screws and a small rubber hose.
Once out just a matter of separating the dispenser draw via 10 small clips. A good soak and scrub and l blasted it through with a hose pipe jet. Reversal of above and now works a treat.
Tip take picks before you startSent from I pad

Hi,

Here is a tip that I wrote about what I found out about the fabric softener not dispensing into the washer...

Fridgidaire Washing Machine Fabric Softner not going into washer

heatman101

Hi, remove the dispenser draw and clean out, you'll probably find a load of unused soap and softener gunked up in it

Siemens
WXLP1460 Front Load
Thisvideo will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials

a 4 THUMBS rating is appreciated for answering your FREE question..

Will be dirt in the drawer, take it out give it a good clean make sre the small tube is cleaned too if it has one/.

hi there just try washing the complete soap drawer again in boiling water leave in there for 10minutes to let the hot water work into the gaps and make sure u take all the holders out of the drawer u sometimes have to use a tooth brush to get into the small holes at the bottom of the little funnel what your softener holder goes over also get a small flat blade screwdriver and clean inside that funnel if thats not clean it will stop softener from going away if this doesnt work still then when your softener is supposed to be taken thru the programme make sure the washer opens the valve for the water to go into the fabric softener holder if it doesnt then the solenoid will need replacing as this could be faulty. LET ME KNOWHOW U GET ON PLEASE PETER

fabric softener This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.