Question about Singer Sewing Machines
lower thread up by turning the wheel, nothing comes up. I do hold the upper thread taunt, so it can 'grab I have loaded my Singer 626 sewing machine bobbin properly, and when I try to bring the
lower thread tensions are out of balance. The upper thread tension is too high or your lower thread tension is too low. Make sure your bobbin thread is correctly routed under the tension spring. There
...Lower the presser foot and pull the thread. It should pull noticeably harder.) If it passes this test, continue up through the take up lever,then down through the thread guides to the needle. Make ...
...load type bobbin on my 9020 model Hold the bobbin with the thread pulling down the left side. Set it in the bobbin case. Pull the thread through the first slit, and back to the left. Leave a 2 inch ...
Question about Sewing Machines
...load per instructions. If this model has a transparent bobbin cover, when the bobbin has properly loaded its tensioner, you should see the bobbin thread over and across the top of the bobbin. If you ...
...Lower the presser foot and pull the thread. It should pull noticeably harder.) If it passes this test, continue up through the take up lever,then down through the thread guides to the needle. Make ...
...load the bobbin, but when I try to catch the lower thread with the top thread, the top thread loops around the entire lower casing. When I pull the end of the top thread, it untangles but has not ...
lower bobbin thread tangling While I am sewing the machine stops but the motor is running then it suddenly starts working but when then stops again almost straight away. then when I look at the ...
Question about Sewing Machines
...load the top thread give small tugs to check for snags. They must be stopped. b. Once the top threading is done on top lower the pressure foot. Now, give a tug on the thread. Is the tension really ...
...load bobbin, I am trying to bring the lower thread, but the upper thread is not catching the lower thread, I have gone through the manual, the machine is properly threaded, the bobbin has been ...
67 questions posted
Usually answered in minutes!
125 Questions
116 Questions
88 Questions
79 Questions
49 Questions