GE WJSR2070B Top Load Washer "clean air dome" Questions

...would be causing the air dome not to drain and how can we drain it? Check that the spigot where the Air Dome connects is also clean, it may be full of gunk so the dome gets no water/air

...air dome to clean this. You may have to disconnect the other end of the air hose by removing the screws on the top of the washer, where the timer panel is, to get to the pressure switch that the hose ...

...clean cycle and code SUD came up again and the the F35 what could it be now??? Hi Thanks for using FixYa. Error F 35 means ANALOG PRESSURE SENSOR FAILURE- If this failure is displayed then there is ...

...air dome or pressure switch hose. The air dome is located on the back of the tub on the left hand side. If the pressure switch hose and the air dome are clear of any blockages, then there is an issue ...

...air dome or pressure switch hose. The air dome is located on the back of the tub on the left hand side. If the pressure switch hose and the air dome are clear of any blockages, then there is an issue ...

...clean out the bottom of the pressure switch system located on the tub? Had a flood problem, did you Chad? Yeah... when that "air dome" on the tub gets all gookused up, the water level switch never ...

clean the soap scum out of the air dome hole. Blow through the plastic tube to hear the water level switch click. Inspect the plastic tube for a hole or pinched. If these steps do not work replace the

...air dome or pressure switch hose. The air dome is located on the back of the tub on the left hand side. If the pressure switch hose and the air dome are clear of any blockages, then there is an issue ...

...air pressure system. The above is from a service bulletin. I have also seen this problem caused by a loose electrical connection between the flowmeter and the control board. Try unplugging and ...

...air dome or pressure switch hose. The air dome is located on the back of the tub on the left hand side. If the pressure switch hose and the air dome is clear of any blockages, then there is an issue ...