Question about KitchenAid Food Mixers
...mixer Worn carbon motor brushes typically cause motor sparking when you're running the mixer. Unplug the stand mixer and examine the motor brushes for wear. To remove a motor brush, use a screwdriver ...
Question about KitchenAid Food Mixers
brushes out of the mixer at any point? I see quite often people remove the brushes, and then they are inserted incorrectly when put back in, the brushes will fit in in any direction, but there is only
Question about KitchenAid Food Mixers
brushes go on the K45SS stand KA Mixer? I was trying to oil my KA stand mixer, and removed a brush, couldn't remember which way it went back in. Now mixer doesn't work. Look carefully at the bruch, it
...mixer is unresponsive when sliding power switch. What's goin" on??? Check the carbon brushes, look inside the hole, it is keyed, the brushes only go in properly one way. Match the missing corner ...
brushes from the mixer, check to see if they are pitted, if they are replace the brushes. Please pay extra attention when putting the brushes back in the mixer, there is a dog-eared side of the brush,
...mixer. It may be that your motor brushes are worn down or have been put in incorrectly. I have added a link below for our help page on replacing your motor brushes: ...
...Brushes mixer works on high speed but not low. Brushes for motor look worn on this 12 year old mixer. Motor brushes are fairly cheap to buy. It sounds like the first place to start: ...
Question about Food Mixers
start. Is there a secret to putting brushes in mixer. Yes there is a secret, the brushes are keyed and you need to line up the cut off corner with the blocker deep inside the brush holder, use a torch
Question about KitchenAid Food Mixers
brushes and the mixer will not turn on they were not aligned correctly to the brush holder. If you need the brushes you can order from about link, if they seem fine I would look at the service manual
...brushes and using a flash light look in the brush holder on the mixer. You will notice a small tab at the very end. That tab will prevent the brush from coming in contact with the motor armature if ...
614 questions posted
Usually answered in minutes!
357 Questions
285 Questions
205 Questions
183 Questions
89 Questions