KitchenAid KSM150PS Artisan Series Stand Mixer "beater touch bowl" Questions

...beater was touching the bottom of the bowl. I turned the screw a good half turn and that solved that problem but than the head would not lock with the beater adjusted. When I put it back to where the ...

...beater/bowl clearance by turning out the adjusting screw. Place your bowl on the bowl screw cap, Place the flat beater on the agitator shaft and lower the head of the mixer so the beater is at the ...

...Beater to Bowl Clearance adjustment screw, then it might appear that your beater had ?grown? because now the beater may be touching the bottom of your mixing bowl, where previously it had not. Simply ...

...beater should just "touch" the coin as the beater rotates. If you have questions feel free to call us @ the Mending Shed. Thank you, Colleen Customer Service MendingShed.com 800-339-9297 I have this ...

beater should just barely touch the dime and move it around the bottom of the bowl. The beater will not scrape the sides of the bowl, if you are wanting the sides of the bowl scraped I would recommend

...bowl. If the beater touches the bottom of the bowl then inspect the Agitator shaft : the retaining ring should be leveled with the surface of the Planetary. If not, then of course the bottom of the ...

...touch the bottom of the bowl. Can you set the mixer lower The beaters dont touch the bottom of the bowl and the mixture doest mix properly. My father suggested that it is probably just needs setting, ...

...beater should JUST touch the dime. If it doesn't touch it at all or is pressing it against the bowl, tilt the head of the mixer up to locate the adjustment screw located inside the shaft. Take a flat ...

...check that the beater does not touch the bowl. Repeat until the adjustment is satisfactory. To lower the beater closer to the bowl, turn the screw clockwise instead. Thank you for the help it ...

...beater doesn't even touch the dime. I even tried turning the screw all the way in the other direction and it's the exact same. The screw won't go any further so I can't adjust it any more. Why would ...