RED LIGHT ON THE FRONT OF MACHINE RED LIGHT FLASHES IT IS THE ONE IN TRIANGLE SHAPE MACHINE RUNS DOES NOT COPY AND TONER CARTRIDGE GETS QUITE WARM HAVE LOST OWNERS MANUAL PLEASE HELP PAULA SHARP AR153-E

The toner light is in the shape of a triangle. If your light is in the shape of a circle you need a developer change. Technician required to do this.

Does the toner cartridge have a electronic chip on it? if so you could refill it all day long it would not change once the chip say the i am done the cartridge is done. Sorry.

Try this site as a start and get a new OEM cartridge

http://olsonbros.com/sharp/parts/list.htm

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Hi r_finch424,

The blink red triangle means that the toner is completely over and can't be refilled. The toner cartridge comes with on-chip sensor that counts the toner life. To resolve this issue, you need to replace a new toner cartridge.

Hope it helps.

Thank you for using FixYa.

This triangle means that the toner supply is needed. It comes first as a steady triangle meaning toner is running low and eventually flashing triangle which means toner is completely empty and copy cannot run. There are two methods of replacing toner ;
Refilling and cartridge replacing.

• You can refill by opening the waste container and then removing the lid on the unit. Use a sprout provided in Sharp Al1000 toner bottle or improvise by folding a paper into a funnel shape.
• For cartridge , pullout the old cartridge and replace with a Sharp Al100td cartridge.

Nice time.

The toner cartridge comes with on-chip sensor that counts the toner life. If you allow it to go empty completely that is it gives red triangle which is steady to warn that toner is near empty. You should replenish toner at this time but if you allow it to blink red triangle, that means its completely over and can't be refilled. REPLACE A NEW TONER CARTRIDGE.

mos the toner light come on is just out of tonert likely is out of toner is it runs for ever and doent come to ready and finely

If the light is a red light with a flash shape then the machine probably has a jam. Look for jams and once you have cleared any jams switch the machine off and then on again. It could be the toner light if there are about six red dots - in this case you need to add toner.

Hello Ms; The red Triangle lite means you need feed them toner, they are hungry !

Yeah thats an easy one. Your really out of toner, the density sensor is seeing a light development patch, and the firmware ( machine operating software) does not have a clue what to do.
I suspect, ohhhh about 99.99999999999999999999999999999999999 percent sure if you replace the toner cartridge your machine will warm up, set up in a minute or 2 and run like normal.
I have seen that time and again on that machine, The software sometimes simply doesnt know what to do with a light copy indication.
The out of toner sensor is a window type sensor, so if there is a little remaining toner on the sensor, yet the density sensor looking at the patch on the drum is light, the software has no clue what to do, so the machine runs, and runs, and runs, and runs...... A new toner cartridge is a almost 1000000000000000000000000000000000 percent fix.

please check if the rubber roller that pulls the paper inside the machine check if it is clean because after long use this roller becomes so smooth ddue to dust and doesnt take in the paper , first clean it ,wipe with wet towel  try again