SOURCE: where is sensor 1 bank 1 located on lexus rx 300 2002
facing engine bank1 sensor 1 should be the one at the firewall area in the manifold
SOURCE: audi a4 2.8 30v 1998 ack engine
It is mounted to the transmission bellhousing on the driver's side. The connector is mounted on the firewall and is a smaller, gray connector. You can reach the sensor from underneath.
SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter
Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger
SOURCE: crank angle sensor location
The crank sensor is always located next to the crankshaft pulley. it will be inserted into the block with the top part of the housing half way out. you cant miss the wires leading into the tip of the housing next to the crank shaft pulley.
SOURCE: where is the crankshaft position/crank
Hi, at the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump
The crankshaft position sensor is mounted on the engine near the crankshaft.
Operation
The crankshaft position sensor is a Hall-Effect sensor that senses the crank angle (piston position) of each cylinder and converts it into a pulse signal. The signal from the sensor is relayed to the ECM to indicate engine rpm and the position of the crankshaft.
Removal & Installation
Temperature - 4°F, test specification 1500-1700 RPM Temperature 32°F, test specification 1350-1550 RPM Temperature 68°F, test specification 1200-1400 RPMTemperature 104°F, test specification 1000-1200 RPM Temperature 176°F, test specification 650-850 RPM
983 views
Usually answered in minutes!
×