20 Most Recent
Questions & Answers
Where is the transmission relay at on a 2002 Mitsubishi Lancer ES?
The transmission does not have a fuse, only a power-up relay located in the under hood fuse panel, near the front of the panel.
If there is a problem with this relay, your transmission will reduce to fail safe mode only. Fail safe is the mechanical-only control which leaves you with Park, Reverse and 3rd gear only, provided there are no internal failures.
What exactly is the problem you are having?
Radio, clock, interior light and central locking not working
This is as a result of a short occurring most likely in the radio harness.It happened me while working on a customers car. In my case checked all fuses and they all appeared fine, both those under the hood/bonnet and those underneath the steering wheel.After studying the workshop electrical schemmatics for the car it appears that the clock, interior lights, central locking receiver and radio permanent live/battery are all on the one line.In effect damage had occurred after the internal fuse panel, therefore all fuses were ok and supplying power across them, but at some point after there was a break in the wire.However you DO NOT need to remove dash and or replace harnesses to rectify.Look at the fuse panel underneath the steering wheel. Slot 18 (bottom RHS) and you will see in raised plastic 'BACK UP'. Inserting a 10A fuse here will restore the interior lights, radio, clock and your central locking.There is a small plastic piece in the way which prevents a fuse going in. Simply use a thin pair of pliers, scissors or a screwdriver (or similar tool) to break this and all pieces of it away until you are able to insert the 10A mini blade fuse.Problem Sorted!(I believe the fact this back up exists is because the designers of electrical system at mitsibushi realised it had shortcomings or this would be a potential problem - and included the back up for such an occurence)Fearghus Quinn(7 years experienced auto electrician & owner of Car Audio company in Perth Western Australia)
Can you please tell me where is the fuel pump on a
The fuel filter is located WITH the fuel pump AKA fuel module is what Mitsubishi calls this bundle, to access remove rear seats where you will find the cover to the assembly. The Fuel pump and Fuel Filter are intergrated to each other to save weight.
2002 Mitsubishi Lancer OZ brake
The first step is to check the bulbs in the tail lights. The brake light switch (on the brake pedal) is OK, as the center light works.
Driver side door window & door lock control doesn't work
does the master switch have a other door lock button
so central locking and windows dont work as they should
driver side window motor faulty
individual door lock actuator motors not getting power
it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner
What is the solution to P0190 fuel pressure sensor 1
either check the circuitry , will need workshop grade equipment and expertise , which is the preferred option , or just change the sensor and hope it's that and not in the circuit , no real short cuts with these electronic problems
4g93 gdi engine starts wont rev above 3000
Hey have you tried disconnecting and re connecting the battery? my mitsi carisma startd doing that so i rang up dealer and aparently they do it when the computer thinks there is something wrong with the engine, so it enters slow mode (or turtle mode or something) so that minimal damage is done while you drive it slowly to yr mechanic. Could be complettly wrong tho. Good luck.
Gdi 1800 cedia wagon-odometer 80,000km exact, starting, no power
Hi it sounds like your high pressure pump needs replacing. the pump can be repaired but you will have to find someone who knows about it, i fix a lot of them before. there is a spring that pushes out the piston in the pump so it can compress the fuel that spring losses its ability to extract the piston back out. i have pictures of one if anyone wants to see
I have a mitsubishi lancer cedia model 2000
If you have the GDI model,they were designed to run on very lean air/fuel ratio.
Once the mileage is up a bit a lot of problems can be traced back to a high carbon build up in the intake manifold.
Filter behind glove box for lancer
Here are instructions on how to remove a glove box on a Honda Accord: 1. Remove these items: Dashboard center lower cover and Passenger's dashboard lower cover. 2. Remove the screws from bottom of the glove box. 3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch of the cap, and release the hooks by prying up the cap. 4. Remove the screws. 5. Release the hooks, then pull down on -------------------------------------------------------------------------------------------Car Diagnostic Tools
My lancer glxD 's clutch
I tried the DIY
service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com
Not finding what you are looking for?