LOST ONLY KEY FOR FORD 2000 CONTOUR V6. NEED KEY CODE. LOCAL FOR DEALERSHIP ONLY GOES BACK 10 YEARS, EVEN WITH PROVIDING VIN # and title.

No 1996 vehicle uses E85
That product wasn't even thought of or
available until a few years ago
The is 85% Alcohol & will ruin your entire fuel system
The car wasn't designed for that fuel,no idea why you
would even go there,just silly

go to the dealership with your ID and VIN #. (license plate number too)
Tell them what happened.

Most often, they need the vehicle there to program the new stuff and to make sure you aren't stealing someones car.

Key code for KEYPAD located in drivers door? Ths is located in label Security Module; if need additional details, just contact us HERE.

Good luck.

You will need to tow to dealer , the dealer can use the cars vin number to cut a new key and reprogram the transpoder,, this is the only way i know about.

You should contact a good lock smith,most of thease guys can re programme a new key all you need is to remove the door lock and a new key can be cut from this.Also they will be half the price or more than a dealer.

yes they can. Otherwise you can go to scrap yard and get new key and ignition

If you want to initiate a new master key.... 1. Insert new key into ignition cylinder and turn it to the ON (RUN) position. The security light on the dash will flash for fifteen minutes.
2. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder OFF and then back to the ON (RUN) position. The security light on the dash will flash for fifteen more minutes.
3. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes.
4. After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car. It has replaced ALL the previous electronic key codes and is the ONLY key programmed into the vehicles computer.

The dealership should be able to do this for you without a current key, of course this means towing the vehicle to them. See if they will sell you a key and you program it yourself.

hope this helps. I found the above info at FordF150.net

Go to any Ford dealership with your VIN #, and proof of ownership, and they can cut you a key. A good locksmith can do the same.

Contact your local Ford dealer. They may make you tow the car in or just provide proof of ownership (registration, bill of sale etc) that has the VIN number on it. They can find the right key with the VIN. Hope this answers your question. Best of luck.
Greg

take the vin # and your title to your local ford dealership, they can cut you a new key, but you have to show them that your the owner of the car.. good luck keith..