The USA 2.0L engine, key words, country and engine size.
the 1million post with guy working an engine can say what is there.
amazes me. .that....
its been posted on fixya before , the 2.0L engine.
did you search, answer , no....
and want both, but failed to ask it bolts are
1: REUSABLE
2: OR TTY
That is first on all modern engines.
as is do i use degree';s or torque on this engine?>
do so on all engines.
why not use the FSM book from suzuki and read.
like we do, we look read and know.
in 5mins work.
$4 read
https://suzukipitstopplus.com/Products/1068-2007-forenza-reno-service-manual.aspx
so ill login to my carppy online clone of above
and say what's there.
why ask for internet rumors on car engine rebuilding
what if the rumor was WRONG.? that work for you>?
no my rumors.. usa cars
2.0L
and these words, step 1.
"Cylinder head bolts. Tighten the cylinder head bolts gradually and in the sequence shown. Tighten the cylinder head bolts to 18 ft. lbs. (25 Nm) and turn the bolts another 3 turns of 90 degrees using the angular torque gauge KM-470-B."
again, our USA 2.0L engine only,
it does not state new bolts.
end rumor off clone, FSM site , USA>.... YMMV....
your motor may vary.
Be more specific every engines are different
SOURCE: chevy 5.7 17 bolt heads tork specs
Cylinder Head Bolt (Preferred Method) All Bolts First Pass in Sequence 22 ft.lb Long Bolt Final Pass in Sequence 75 deg. Medium Bolt Final Pass in Sequence 65 deg Short Bolt Final Pass in Sequence 55 deg. Cylinder Head Bolt (Optional On-Vehicle Strategy) First Pass in Sequence 26 ft.lb Second Pass in Sequence 44 ft.lb Final Pass in Sequence 66 ft.lb
SOURCE: 87 samurai bolt torque specs for engine
The haynes book is not recommended since there are numerous mistakes and they still will not update. One of the biggest is the firing order.
The factory service manual is the only way to go.
Head bolts - 46 - 50.5 lbs (there is an order sequence for the bolts)
Intake & exhuast manifolds- 13.5 - 20 lbs
Flywheel - 41.5 - 47 lbs
Clutch cover - 13.5 - 20 lbs
SOURCE: head bolt torque spec
Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.
SOURCE: head bolt torque specs for 2000 dodge neon 2.0 SOHC
I have the specs and diagrams. If you want me to send them to you, give me your email address. [email protected]
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
1,336 views
Usually answered in minutes!
×