Need picture of thermostat location on a 2000 Chrysler Sebring w/2.5L engine

https://www.cargurus.com/Cars/Discussion-t4058_ds576636
How do change the thermostat on 2000 chrysler sebring Jxi


How do your change the thermostat on 1999 Chrysler Sebering

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

Click over image for zoom...

Fig. Air bleed valve (1) and thermostat housing (2) 2.7L-engine


Hope this helps (remember to rate and comment this free answer).

Thermostat location.

to the front of the engine, just behind the radiator you will notcie 2 wires connecting to a part on the engine, close the the manifold. thats the thermostat. Its close to the radiator hose,,

follow the lower radiator hose connect to the engine and thats your thermostat housing.

follow the large radiator hose from the radiator to the engine, you'll see a large clamp holding the hose onto the neck thats bolted to the engine block, under the neck is where your thermostat is located

the thermostat is a bolt on the side of your engine block with two wires coming off of it, maybe only one.

Follow the TOP hose on your radiator to where it connects on your engine block. The thermostat is under the metal piece mounted to the block which the hose is connected to. It typically has to bolts to remove and you will find the thermostat under it once you remove the mounting.

If you follow the upper radiator hose from the rad to the engine you should find it.
It will be under the housing that the rad hose connects to on the engine side. Usually the housing is held on by two bolts.