20 Most Recent 2007 Chrysler Sebring Sedan Questions & Answers

Here is the definition.P2017 CHRYSLER - Intake Manifold Runner Position Sensor/Switch Circuit High Bank 1Possible causes - - - Manifold flow valve harness is open or shorted- Manifold flow valve circuit poor electrical connection- Faulty Manifold flow valve- Faulty Powertrain Control Module (PCM)You'll need someone with a shop manual to get the testing procedures.

2007 Chrysler... • Answered on Apr 26, 2021

On my 2007 sebring 3.5. I just changed map sensor went rite off located on right hand side manifold

2007 Chrysler... • Answered on Apr 16, 2019

Read this post on how to diagnose the problem. http://ricksfreeautorepairadvice.com/power-window-not-working/ But in the meantime, there are only two ways to get the glass up: Disconnect it form the window regulator and tape and block it in the up position, OR cut the cables to the window regulator and block it in the up position. If you cut the cables, you'll have to replace the regulator. Power window not working Ricks Free Auto Repair Advice

2007 Chrysler... • Answered on Jan 21, 2018

It depends on the car. If the car has alot of load on the transmission going uphill, it can make the car gobackwards. Many reasons. Weight, what type of car etc. It isnt something I'd worry too much about. Just have your foot on the brake when you stop

2007 Chrysler... • Answered on Nov 19, 2017

Sounds like you are sure it is out side. Just want to mention I have change out 2 actuators in my Chrysler 200. They start clicking, it is the plastic gears slipping. I would hear them and then I did not. They control the vent, A/C and heating ducts/air under the dash. They can be soft and sometimes loud. Do not know if this helps but I listened to the clicking a couple months before I started to check it out. The plastic gear turn on plastic shafts. I put Dorman in and it is plastic gear on steal shaft, at least the actuators I put in.

2007 Chrysler... • Answered on Aug 02, 2017

You should be able to feel the exhaust pressure coming from the tail pipe, will be weak flow. . I usually unbolt the catalytic convertor and look inside it, you can see if the "passages" are stopped up or it has melted into a ball like happened to my wife's suv. she idled too long in it which melts catalytic convertors. You can run the vehicle with the exhaust open to see if rev's quickly but a check engine light will come on showing the oxygen sensor is out of the exhaust.

2007 Chrysler... • Answered on May 12, 2017

You'd better take it back to them... they missed something. Better yet, I suggest you take it to another Chrysler dealer and take your service receipt with you - those other guys may have left a clue in what they had to say about the problem and what they did.

2007 Chrysler... • Answered on Apr 06, 2017

In a factory service manual, it is broken down into sections. So there is no one exploded view in the book or online.

2007 Chrysler... • Answered on Feb 15, 2017

Not finding what you are looking for?
2007 Chrysler Sebring Sedan Logo

936 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

14869 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers


Level 3 Expert

4376 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sebring Chrysler

  • Sebring Chrysler

Most Popular Question

electronic throttle control warning

  • Cars & Trucks