Questions & Answers for: true cooler thermostat adjustment

TRUE COOLER COMPRESSOR CYCLES ON 45 SECONDS AND OFF FOR 2 MIN. TRUE COOLER COMPRESSOR CYCLES ON 45 SECONDS AND OFF FOR 2 MINUTES.SEEMS TO COOL FINE MAINTAINS 38 DEGREES, OTHER TRUE COOLER WE HAVE DOES

...Cooler Door gaskets or someone left door open for a time. Thermostat set to low. Low freon expantion valve out of adjustment or needs replaced Freezer Defrost not working (Will have heaters with a ...

...thermostat down, we can get the cooler to go down to the 20's Fahrenheit, but even set at a warm temp, the evaporator ices up. possible bad defrost timer,or control on an off is bad,were you adjust ...

...true cooler gdm-45 is showing too much variation in temperature like from 32-44 after adjusting the thermostat various times. What is bad? The thermostat seems to be bad. Or, the defrost timer is ...

cooler will not cycle off when temp is reached. Just keeps running and becomes a freezer instead of a refrigerator. Where is the thermostat adjustment locatd on a True Model T-23 Inside of the unit on

...true GDM46 and I cannot get the thermostat to adjust to a temperture of 36-40 degrees. What number should it be set at and why does it goes below or above the set you are trying to get. I put a new ...

...Evaporator fan always runs the compressor is controlled by the thermostat you could have a bad thermostat if the compressor never shuts off. Possible temp contol sticking or adjustment knob is on

...cooler and recently it became so cold that bottles broke and made mess so we adjusted thermostat but then it became too warm. Ever since that we are trying to make it so it maintains temp at certain ...

...True tssu-60-16 Food is freezing. Thermostat is set at 1, yet it still freezes. if you tried to adjust the temperature and the cooler continues to freeze the food then replace the thermostat attached ...

...true cooler for bottles and i dont knowhowto make it cooler I see the p,ace to adjust it but don't u dersta d what to do If it is a number thermostat, first check your box temp., then change the dial ...