Whirlpool Duet Washer When the washer goes into the first drain and spin mode the inside drum appears to be off balance as it spins unevenly and sounds like it is hitting the sides. It wobbles ...
...drum. Two of the three are loose. With the door open I can shake the cleats a small amount and this may be the sound I hear when running. Has anyone had this problem or know of anything else to look ...
...drum to sag when first loaded. Both are replacable items with the back / top off. The biggest thing to look for on front load washers is not weather or not they are level, but more weather or not all ...
...nut off with my Dremmel. My hypothesis is when the drum is overloaded it puts stress on the shaft/pulley connection and the softer metal gives way. Over time the key becomes rounded and the pulley ...
...Whirlpool reasons for you. But if nothing helps you may have a mechanical problem to be serviced! Try these ideas first! Is the load balanced? A single or bulky item may cause imbalance. Add more ...
...drum over is something else, to check drain remove lower cover and open pump cleanout also feel the rubber hose from bottom of tub to pump to see if a object is in it. take hose off pump to clean out ...
...duet front loader very loud durnig spin cycle and has a burnt smell at the end of cylce hi valeriekate...The washer must be level and properly installed, and the nuts should be tightened against the ...
...the belt is tight,tighten bolts and nuts,good luck.adrian;;;; you dont need to loosen motor just put the belt on the motor pulley and start on drum pulley and then turn drum pulley. it will slip ...
...drum spun a time or two. Is the pulley supposed to be loose like that? It seems to make sense that a loose pulley would put the belt out of balance and that that is what would make the new belt come ...
Question about Gold Duet GHW9400P 3.8 Cu. Ft. Front-Loading Washer
...DRUM BEARING, the balance or counter weights. THE DRIVE PULLEY- If the washer is making a loud noise the drive pulley might be worn out, cracked, loose or bent. Remove the drive pulley and inspect it ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions