Images have yellow tint/colorization. Replace lamp and images still have yellow hue. Tried changing color settings and this does not solve the problem. HELP!

Default your options to factory settings to see if the white balance setting or a type of light setting is wrong.

check whether the printer is in proper mode or not

This will depend on the brand, model, cable connection type and OS of the laptop. Most have a color control which you can adjust.

You can only remove it by bleaching it. Usually though, we merely neutralize yellow by applying a permanent tint, demi-permanent color, semi-permanent rinse, or a colored shampoo in a complementary color, that is a hue that is opposite yellow on the color wheel. The hue most often used is violet.

hello,

what this indicate from the color display on the system mean that the display sensor (lens)in getting weak it need servicing or a replacement, to to this servicing you will have to unscrew (open) from the stroll then clean up the lens with little spirit solution on the surface with care allow the solution to dry up it self then reset the programming on it please while doing this you will have to be very careful with the wire connection around ,but if this fail then you will have to get a replacement on it

This are recommended fix is to replace the lens. You can generally find replacement parts at these websites:

www.projector.com
letsgodigital.org
comforu.com
technabob.com
techshout.com

All these sites offer great service with competitive pricing, so shop and compare.

Replacing a lens is not a difficult repair and can be accomplished by the average do-it-your self offer. If you decide to order the part and wish to repair this on your own

thank you and thanks for you sing fixya.

2 things the cable could be faulty (unlikley)but worth a try
or your lamp is starting to fail

Try adjusting the brightness on the monitor

As TVs age, the rate at which the CRTs begin to decline in terms of light output increases. If you go into the customer menu and adjust the color setting to zero. ( no color) observe the image. Is it good gray scale? Or, is the image still green tinted? If so, its definitely a problem with the CRTs( picture tubes) You may need to just re-adjust the screen settings for the CRTs or it may be more serious, a CRT may be bad. Replacing the CRT is a job for an expert and will cost $500-700.

michtech

Pls check your color Scan settings. Generally there will be some color difference between the original and scanned Image because, the original is 'reflected light' whereas, the scanned image is a 'source light' on the monitor. The monitor setting can also affect the color output. S. Mohan

Hello,
If you have RED color that starts from Center of the Screen,(no red color on sides ) 100 % your light engine is deffective..
In order to solve this issue Replace Light Engine Control Board (also called Driver Board ) attached to light engine.

Good Luck

Do not forget to Rate!!

Dals123