Prints in yellow but not in black do not no what to do have new driver but dose not work

I think this is a pretty old printer. It would cost more to fix than a new one. I recommend you recycle it.

this happened to me, too. printer starting using all of my yellow ink.
The ink container was the problem, defective. it took several changes for it to print in black again...5-10 cleanings.
make sure the black cartridge is not defective by trying another one in it's place. if you can, use the yellow for the black slot, then switch back a few times ( I tried to re-install the drive, but the in was the problem). Good luck.

Hi, please get new driver here: www.driversdown.com/
www.nodevice.com/driver/company/Canon/Printer.html
www.usa.canon.com/cusa/office/products/.../hs_1200ts

Jay pklo

hi this is kamal..

you may refilling your both catridge of printer and if it does not work then u can purchase new one...

thanx for choosing fixya

regards
kamal singh

what are you trying to print in black? the best way to test out a black ink is to open word pad and type some thing random and print it and see if that works. if you have a all in one printer u might have 2 inks one color and one black in the printer

fist of all reunisall your printer driver ....
if problem dose not fix .
it means black colour laser section have problem so you can clean lens of laser if posible and replace laser secaner.


thanks

Clean the Nozzles of the printer, you can do this by the printer driver.

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

i have installed the drivers but its saying drivers have been deleted?

This is what worked (so far) with my Dell AIO A940 printer that wouldn't print black ink.

It worked for awhile when I chose photo/glossy paper, but then it quit printing again (see below).

PRINT, PROPERTIES, PAPER SETUP, SPECIALTY PAPER, PHOTO/GLOSSY


I got it to print, again, by putting SEVERAL papers in the feeder (instead of just 1) - there is a sensor that is supposed to automatically detect paper type, and it might not be working right, especially with one or only a couple of sheets.

I had the same problem with the yellow cartridge. Yellow quit printing, put in a new yellow and still would not print yellow. I had a help file, don't know where I got it, but it suggested replacing the black ink cartridge also, even though the black wasn't low yet. Replaced the black, ran a few nozzle cleans and everything worked fine. Don't know why. Try it