B-SX5T password issue

Use an appropriate Ribbon.
Check that the slits on the ribbon detection is not full of dirt.
check that your ribbon motor parameters are correctly set.

chage the value in the temperature adjustment or directly on the printer in the adjusment menu, or use the seagull driver

A lot of printers you can put special commands in a text file and just send it as a print job. You will want to consult toshiba for commands. Also lots of printers accept commands via telnet. You can use putty to telnet to the printer. Also many printers have web interfaces to configure them.

what is the exact meesage?

Hi, there is no recall for the igntion switch. The best solution is to replace igntion switch. If you need more info just re post.
Thanks dodge tec

This type of error message usually means a command error has been found in a command received by the printer. 16 bytes of the command error, hence the XS;I,0001,0012C5 message. It starts from the command code, XS.

I am not sure of all the command codes but I would suggest starting by re-installing the printer driver.

Either you use a driver or send
{T20C51'}

If this issue started with a motherboard error that appeared to be a faulty CMOS battery and then it started incorrectly detecting your memory and now is asking for a password it could be a faulty motherboard. If you are 110% you or anyone else has set a password on that laptop then I would say your motherboard needs to be replaced. It is a difficult process to reset admin passwords on most laptops due to a security chip that will prevent the trick of removing the battery from working. In all honestly if no one has set a password and the motherboard THINKS someone has then even if you reset the password you will still have issues. There is a small chance your CPU or RAM could be defective. But, again going back to it saying you have a password set that was never set. It just yells faulty motherboard unless someone has set a password without you knowing.

Try ramclearing the parameters.
Else
You have to send the firmware on top of the actual one