What to feed a snail and how to feed a snail what is good for it and what is bad for it

Is your machine mechanical? If so, sounds like the feed dogs are stuck in the lowered position. Needs good cleaning and oiling.

Perhaps this will help:
The feed dog knob won turn don think anything is broken haven used the...

...

You may have lint build up under the needle plate between the feed dogs. Pop it off and clean it out.

If not that then maybe the feed stepper motor is going bad.

Good luck!

check in the manual and see where the feed dog lever is a check to see if it's in the up position for sewing or in the down position for darning, if it's in the up position, then the machine needs to be checked to see if there is something wrong with the feeddogs or the feed dog lever..

The top one with the bobbin on it is for winding a bobbin. When you press it the bobbin winder spins around. The bottom two are for if you don't want to use the foot pedal. The second of these two, which has a O/I sign on it, makes the machine stop and start. The one with the snail and the rabbit controls the speed.

Manual seems to imply that you have to cover the needle plate with a "darning plate," which just build up the area around the feed dogs so they don't reach the fabric--pretty inelegant, plus I wonder if you can even find the darning plate anymore. Let me know if you figure out anything else!

there called feed dogs & if they don't feed the fabric thur the machine need they need to be check to see whats wrong with them

check the feed dogs to see if their up, you can see & feel them with your finger under the needle plate.
if the feed dogs are not up then somewhere in the cleaning the knob or lever got moved, go back thru what you did to find the feed dog knob,,it's always good to know where it at

are they clean? give them a good brush clean regularly with your little brush in the sewing machine kit.

However, if there seems to be an issue with feeding and the stitch formation, then the timing could be out and it may need a professional service.

Remove the needle plate and check for lint build up between the feed dog teeth. Lint will build up and prevent the feed dogs from coming up all the way. I them still don't come up high enough, then they will have to be adjusted.

Possibly the touch pad is bad. Are they any other buttons that don't work? Usually when the touch pad is bad other buttons won't work either. If only the stitch length won't work then the step motor for the feed is bad or you have a bad board.