Ho heat when drying cycly all else is ok. faolt code is f000

https://printcopy.info/?mod=erc&brand=Kyocera&model=ECOSYS+M2040dn&code=F000

p0336 is faolt code for crankshaft position sensor fault check the wiring to the sensor and check the reluctor

Code
F000
Description
Main PWB - operation panel PWB communication error
Causes
Defective main PWB.
Defective operation panel PWB

PWB = printed write board

https://printcopy.info/?l=en&mod=erc&brand=Kyocera&model=FS6525MFP&code=F000

Heat code. You will need to reset in service mode.1087 1087 function find reset fixing assembly and activate. If it comes back you have a bad bulb or a bad thermistor. Could be a thermal switch . It's the fuser assembly.

see this mean :Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.
Read more: http://www.appliancepartspros.com/repair-help/hotpoint-fault-codes.html#ixzz2gUdlkOnE
http://www.appliancepartspros.com

just give some heat to flash ic with some flux & try to flash it will be ok
flash ic ko thori si heat de kar dobara flash karo theek ho jay ga. yeh flash ic ka fault hota hay
koi bhi UFS programm flash k liye use ker sakte ho
best of luck

Their are 2 types of dryers. Electronic dryness sensing style and Autodry style. Yours is Autodry.
Electronic dryers have a dryness board which relies on info from moisture sensing bars that the wet clothes rub against. AutoDry models like yours alternates the power between the heating element and the timer motor. This is what you heating assembly looks like:


Check all the components on the heating assembly for continuity.


I have a service manual and more HERE



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

IF DOESNT HEAT UP ANYTING CHECK THE THERMAL FUSE AND REPLACE IT IF NECESSARY!!!

IF IT DOES HEAT UP A LITTLE IS NOT THE FUSE!! IT COULD BE THE EXHAUST PIPE (DUCT) CHECK THAT IS NOT BLOCKED OR CLOGGED!!!!

Make sure u have seleced the high heat setting..The fact that it is heating more or less indicates that the element is o/k.
Check and clean any filter(s) that u can see,it is more likely to be a thermostat problem than anything else. and there are at least 2 of them, also check line voltage is correct.
Plz rate this solution.
thanks.