LC 32LG5000 remote not working

Hello everyone, I have had the same problem with the remote control already for 4 years. I solved it a few minutes ago :). If this is still relevant for someone, try hold “Power” + “Menu” on your remote for a few seconds until the TV button starts blinking.

TV: 32LG5000
Remote: MKJ40653802

From Russia with love

Hi there,

Well first you can try - 065, 244, 405, 318, 037, 398, 191, 459, 245, 389, 060, 275, 0206, 0584, 0742, 0851, 1165, 1176, 1208, 1219, 1280, 1293, 1665

if none of the code works for you then please follow the below link to know how to search your sky remote code -

sky.com/portal/site/skycom/skyhelpcentre/producthelp

also check the below link
skyuser.co.uk/tools/remotecodes/index.php

Good Luck!!

I had the same issue with my Sharp Aquos 52 inch LCD TV. I called Sharp. The tech had me unplug my TV, take the batteries out of the remote (TV remote not cable) and press all buttons on the remote (including the buttons under the flip top at the bottom of the remote). I did this, put the batteries back in and plugged in the tv and everything worked. I had gone 4 months having to use the surround sound for volume and turning the TV on and off by hand. This took 2 minutes to fix.

my toshiba remote or any remote doesnt work?

Sounds like power supply or control board problem. Trace down the noise and replace board. Sounds like 100-150.00 problem - hope wrong.

Make sure the remote is set to operate your tv and not a cable box or accesory. It's in the menu

Try the buttons on the TV to verify that the set is working. Then;
Step 1- Pull the batteries out of the remote and leave them out until Step 4.
Step 2- Press and release each and every button one at a time on the remote control until every button has been pressed and released at least once!
Step 3- If your remote has slide switches, you must move the switch to each position then repeat the button pushing in Step 2.
(When you're done, be sure to put the slide switch in the correct position to operate the unit the remote came with!)
Step 4- Put the batteries back into the remote, being very careful to install them correctly.
New batteries should be used if you're not sure about the old ones.
If you are still having problems, you may have to replace the remote.

LOOK MIN TH EBACK ON THE MAIN CONTROL BOARD AND THERES A FUSE THAT YOU MAY HAVE BLOWN

http://www.xdiv.com/remotes/

TV is under warranty. Get a tech to look at it. It could require a new IR sensor, a firmware upgrade or a system reset that only a tech can do called an Industry Initialization that is in the service mode only