I have a Toshiba CX32D60 with sides of screen bowed inwards ( narrow in the middle). Sound bar raises and lowers - sound audible only, close to the plus (+). Any help will be appreciated. Thank You.

Follow these steps :
(1) With the printer turned on, unplug it
(2)Open the top and bring the ink cartridge holder to the middle
(3)Raise the gray bar and remove the print head assembly with the cartridges in it
(4) Lower the gray bar with the head missing and close the top with the head out
(5) Restore the power,wait til the printer wakes up
(6) It will tell you to put in the cartridges
(7) Restore the print head, close the top and the printer should resume working..

To fold the buggy, it is necessary to operate both a primary lock, and then a secondary lock. Start by making sure that the front swivel wheel is locked. Operate the primary locking device by pulling upwards on both of the plastic tabs located on the side of the handle arm just below the foam handle grip. Begin pressing downwards so that the pushchair begins to fold. Next, release the secondary locking device (raising the bar located lower down on the left-hand side) and continuing pressing downwards on the handle bar until the pushchair is fully folded. The handle bar can then be folded inwards to the maximum, by pressing simultaneously on the adjuster buttons on either side. Finally, with the chassis laid down, lock it into its folded position by closing the folding latch operated on the side.
Operating instructions, with diagrams, may be obtained from [email protected]
I hope that this is helpful. Do leave some feedback, so that we know how you got on!

Go to control panel, -> sound -> sound and audio devices ->sound and audio device properties -> check the first tab for, "place the icon on the task bar".

sound like you have a broken wire to wind motor that making intermintant contact ck where wires come into door assm

There's a miror or one like this might have a ''aluminium sheet'' miror.
Open the upper back cover to see what going on there, pretty sure something run out of place...

sounds like a bad capacitor in the deflection circuit or a leaky diode which is causing the problem. Adjusting wont help.

change the electrolytic capacitors in the vertical section of tv. you do need a qualified tv tech to do this repair for sure

If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/ Convergence and other adjustments of many popular brad PTVs are given in detail.

about the zenith it seems you have the flyback transformer malfunctioning - try to change it - delfo

It sounds similar to my Toshiba 62HM195 that I posted about except my screen is spit down the middle and my bottom half is messed up but the upper half is Ok.  I have been told it is a bad Light Engine Part # 23405481.