Machine says it's FULL, and won't shred, but it isn't/

You will need to replace the latch/lock. Here is that part to order.

The sensor in the bin that detects the ice to tell if its full could be bad. That or the control board.

Turn off machine and check water waste filter to see if blocked should be at front at bottom of machine or at back,not sure this is the cure but hope it helps

Silverfox007:

There is a paper sensor at the throat of the machine that turns the machine on when it is activated by the paper when the paper is inserted. Something has happened to that sensor. Unplug the machine and remove the shredder head from the basket. Use a screwdriver to remove the screws at the bottom of the shredder head and open the shredder head. Look where the paper is fed into the machine and you will see the sensor. It may be unplugged/wire broken/sensor flag broken off... You'll know what to do when you identify the problem.

If you just drained it & are refilling,then yes,the engine
should run & warm up until the thermostat opens & you
keep adding.

If it isn't hot & circulating thru the entire system, you won't
get it close to full with the rad cap off

you could just have dead cell in the battery which isn't getting enough amps to the starter,, have the battery LOAD checked,, that will tell you if the battery is actually good, just because it registers 12 volts isn't necessarily an indication that the required amps are present.

Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101

';';

You need to check the pump, the best way would be to take the machine outside and to disconnect the hose to the pump, that will allow the machine sensor to reset, you need to check for an obstruction in the pipe feeding towards the pump.

The below doesn't work with all Panasonic equipment but if this fails then the only fix is a replacement Laser which isn't cost effective.

U61 Fault
Corrupted or Faulty DVD in Machine.

1. Put Machine into Standby
2. If won't go into Standby hold 'Power' for 5-10 seconds
3. In Standby hold 'Stop' & 'CH UP' together for 5-10 seconds until tray opens

If this fails then re-initialise the Machine as follows

1. Put Machine into Standby as above
2. In Standby hold 'Stop', 'CH UP' & 'Open/Close' together for 5-10 seconds.
Hello displayed followed by TM AV1

3. Put Machine into Standby
4. 11-11 then 12-12 and finally 22-22 displayed

Switch Machine on and Retune

Check and make sure the paper catch bin is locked into place.
IF the shredder doesn't see that the bin is in place, the shredder will appear dead for safetly reasons.

There is a possibility that the control board was cracked but the only way to check that, is to take it apart and check.
Good luck.