Getiing an error code on a sharp sf-2052 copier

its an error code for the fusing unit

It seems your copier has a low battery?
check this page: Sharp Copier error code codes AR sharp errors copy

Ar163 F5 = Copy lamp problem.

Possible causes are:

Blown Copy Lamp
Inverter trouble (copy lamp driver module)
MCU Board failure

This is most likely to be a blown copy lamp.

Ar2030 F2 is a process control error - depending on the sub-code it could be a number of different things. Please repost with the full code.

Hope this helps.

enter code 14 press copy key

Hello sir; It can be reset by power on and open the front door, press and hold exposure key while you closing front door.

How do you do. You should check join from the main of the charge to device сортера.If connections is checked and where are no mistakes in join no pay attention to mechanical possible damages, findings scrap papers and stranger subject in sorter device. Recall, pr what circumstance appeared the fault.Error code F1 for sharp copiers sf 2020.2030 Sub code 00: Communication error between main board and sorter. Sub code 02: Sorter transport motor drive.

C INTERRUPT 0 INTERRUPT
14
START

If the sorter has a problem, disable that option by command 26 print 01 print and enter 0 enter.

GO ON LINE AND TYPE THE FOLLOWING:

SHARP SF2020 COPIER ERROR F CODE
ENTER
OR
WWW.SHARP.COM/COPIERS

ROD

It's hard to be sure because our model numbers are different but drum reset should be 24-7 and dev reset should be 24-6. Good luck