HP LaserJet 2420 Printer "remove roller marks" Questions

roller marks is the fuser. In order to do this. You will have to remove the back panel. Unscrew the fuser.*note fuser can be extremely hot after use. be careful.* From this point you should be able to

...remove the pick up roller releasing the side locks, clean with wet cloth, fix it back then try once, if its success..end the process.. if not replace pick up roller..observe similar kind of ...

...roller to remove loosened dirt. Figure 7: Wiping the roller to remove dirt and debris Allow the pickup roller to completely dry before reinstalling it in the printer. Figure 8: Allowing the roller to ...

...remove the entire fuser unit. Take it to another table and dismantle it. Cleaning this roller will not help. Replace it or don't bother to dismantle if you will not. Hi try to perform the steps from ...

...Remove the fuser and inspect it. It could also be the transfer roller: When the transfer roller begins to fail, one of the first signs of trouble will be black streaks on the paper. If you notice ...

...remove the feed roller. You should now see the Offending Seperation pad. Cleaning the Seperation pad should be done using a Rubber restoration Liquid and LintFree Cloth. Use the same on the Feed ...

...remove the Tray and look there is rubber roller inside if there are marks or lines on that rubber roller or if the roller roller is worn out than that rubber roller called as paper pickup roller need ...

...under the scanner front area). Also, I would replace the Transfer Roller. When you remove the toner, you will see a black roller that sits just under where the toner normally positions at the

...marks. The cartridge (original HP) is about 3 months old and has not given any trouble until now. The printer isn't high useage, the previous cartrisge lasted 3 years Probally fuser needs replacing, ...