2002 Toyota RAV4 Logo

Related Topics:

Julie Brown Posted on Jan 07, 2013

2002 rav4 interior light only goes on manually is this right?

Can't find a way to make the interior light come on when the doors are opened. Will only do so manually. Is there a way to automate it?

5 Related Answers

Ottoniel

  • 202 Answers
  • Posted on Jul 24, 2009

SOURCE: 2007 Rav4, 41,700 miles. Today car will not start.

check if their is a fuse for the relay for the starter might be blown

Ad

Anonymous

  • 1036 Answers
  • Posted on Aug 04, 2009

SOURCE: 97 RAV4 door won't open. Or unlock

These can be a nightmare!
Try pushing / pulling all cables and rods available. And key operation if connected.
If there is a solenoid to operate it, remove the connector and use a meter to find the motor wires. Cautiously apply 12v from a handdrill battery - first one way - then the other to see if the drive motor will unlock it.

As a last resort - Drill a 1/4" hole in the lock body - and use that as a pilot hole for a 20mm holesaw - destroy the lock mechanism to gain entry - the lock was beyond repair anyway - so needed replacement - Just don't damage other components if possible.

Anonymous

  • 1986 Answers
  • Posted on Sep 29, 2009

SOURCE: removing interior door panal w/o breaking it

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Anonymous

  • 1 Answer
  • Posted on Feb 24, 2011

SOURCE: 2004 toyota sienna manual sliding

I have the same problem. I thought it was an electrical problem. My interior lights would go one and off and I would hear clicking noises. I took it to a mechanic and he said my switches for the sliding doors are bad so he had to order them from toyota and I'm getting them replaced tomorrow. Take it to a mechanic and get the switches replaced.

mark oare

  • 63 Answers
  • Posted on Aug 07, 2011

SOURCE: Well I'm looking for possible

battery cables are totally clean?
hen try this
Use the key to manually unlock the driver's side door. This temporarily deactivates the alarm, giving you access to the inside of the suv.Place the key in the ignition and turn it forward one notch so that the battery activates, but the car isn't running. Look for the alarm box under the dashboard. Some models have an override button that's either black or red. Other models have a toggle switch on the box to override the alarm. Press and hold the override button in until you hear the alarm chirp once, signaling the alarm is disabled. If you have a toggle, flip it in the opposite direction

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Interior lights stay on wile i'm driving my 2005 lincoln navigator

Only one bad door switch should do that

The 20 min time out is the GEM or Body Module,
which is normal only because you have a bad switch,
otherwise it goes to sleep when either front door opens

Put radio on & open a door,the radio should go off
& kill the time delay if no issues exist
0helpful
2answers

1997 Toyota Rav4 driver side interior door handle broken

Parts can be had from a junk yard...remove door panel and push up on the connecting rod to open...generally, a little piece of plastic slips off or breaks inside the door. It is attached to a certain part of the rod. Should be white or clear plastic...look for the broken bits when door panel is removed so you know what you need....cheers
1helpful
1answer

Interior lights fuse

The fuse will be a blue 15 amp generally knee height beside your steering column ,you have to release the panel covering the fuses to see them . best to kneel on the ground with the door open. Find the fuse by pulling out and replacing untill you get the right one, usually around number 25 and sometimes called a courtesy light. The fuse diagram is on the inside of the cover when you remove it. there will be a indent for your fingers to pull on and release the panel/cover. Have you tried manually pushing the switch on the door column and spraying some WD 40 into it ? hope this helps you.
0helpful
1answer

Interior lights and tail lights don't go on for 2002 nissan sentra

you most likely have blown 10amp fuse for tail lights in the fuse box under the hood as far as tha tail lights go. turn your lights on and check your tail lights along with the plate lights. plate lights are on the same fuse as the tail lights. there is a fuse box by the battery which has tail light fuse in it. the lid of the fuse box is showing location of fuse. as far as your interior light goes, make sure that you have the switch in "door" position or it will not come on when door is opened. or just put it into "on" position to see if it comes on. but turn it off or put it back to "door" position/middle seting or your battery will drain down.
0helpful
2answers

Well I'm looking for possible soultuions before I try it . I recently had to put a battery in my 2002 toyota rav4 and my alarm goes off everytime I open the door ...... goes off for 30 secs or so ...

Sorry you can't disconnect it. you should be able to reprogram it though. look in your owners manual. most are programmed threw the radio controls.
Not finding what you are looking for?

79 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...