1997 Toyota RAV4 Logo

Related Topics:

A
Anonymous Posted on Jan 24, 2018

1997 Toyota Rav4 driver side interior door handle broken

Stuck in locked position. Can't open. Was getting worse slowly for 2-3 months. Used to roll window down and open from outside when inside door handle/manual lock faltered -- now it's stuck locked and I climb in the passenger side! How to fix and where to get replacement parts information.

  • Benjamin McCann
    Benjamin McCann Jan 25, 2018

    Pull off the inner door panel and you will find the issue

×

2 Answers

Rick M

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Toyota Master 4,148 Answers
  • Posted on Jan 25, 2018
Rick M
Toyota Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jun 26, 2017
Answers
4148
Questions
0
Helped
1254739
Points
13941

Remove the plastic trim panel and operate the linkage with a pliers. But a new handle from the dealer or junk yard.

alibaba69

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Master 490 Answers
  • Posted on Jan 25, 2018
alibaba69
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Jan 13, 2009
Answers
490
Questions
2
Helped
186612
Points
1312

Parts can be had from a junk yard...remove door panel and push up on the connecting rod to open...generally, a little piece of plastic slips off or breaks inside the door. It is attached to a certain part of the rod. Should be white or clear plastic...look for the broken bits when door panel is removed so you know what you need....cheers

Ad

5 Related Answers

ken_lowe

  • 3 Answers
  • Posted on Nov 13, 2008

SOURCE: driver's door lock will not open by key or electronic fob

I was able to determine if you move the inside door handle toward the front of the car, then you could remove the door panel. However, it takes a little force to pot out the plastic clips, but if you work around the outside by appling pressure with a thin tool, such as a putty knife it will pot out.

My problem was a small yellow plastic part that connects the outside and inside door handle rods was broken.

So I plan to replace the part and see if that fixes the provlem. If so I can save over $340 dealer repair costs.

Ad
ourhowse

Dar

  • 2007 Answers
  • Posted on May 22, 2009

SOURCE: How can I fix the door handle on the inside of 1999 Toyota Coroll

It's probably broken, or unhooked. Just take your inner door panel off, and you'll soon figure out what's happening. Sometimes the rods get bent, or they come off the clip, or just need adjusting. And sometimes the handle itself is broken, but you can do it!

Anonymous

  • 24 Answers
  • Posted on May 30, 2009

SOURCE: Need instructios to repair 1997 Toyota Camry Broken Exterior Door Handle

Two 10mm bolts, or nuts, hold the handle on from inside the door. dont forget to remove actuating rod from old handle. probably clip is broke also.

Anonymous

  • 86 Answers
  • Posted on Mar 17, 2010

SOURCE: The rear door on drivers side of 1992 Toyota

Actually, I suggest going to a junk-yard to get your parts. It will be much more expensive to get at your dealership or bodyshop, plus the huge huge huge labor fee. If you want to invest a few minutes to save yourself some time, look to see what other vehicles use the same door handle yours does, (it will be a toyota).

choprboz5

  • 197 Answers
  • Posted on Jun 03, 2010

SOURCE: Outside handle on 1997 Toyota Avalon will not open door

Since you can get the door open, half the battle is already won. Yes, open the door, pull the interior door panel and take a look around. Watch inside with a flashlight (towards the rear of the door) as you roll the window down to see if you can see what it's snagged on.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

How can I manually unlock my rear door if the actuator is bad. My rear fate door is stuck in the lock position and I can not unlock it with the key fob or auto lock. 2007 rav 4

Access the gate latch from the inside by removing the interior door panel. Once the gate is open, replace the actuator and you should be good to go.

If you need further help, reach me via phone at https://www.6ya.com/expert/scott_843b43f7ebebd3f5

3helpful
5answers

My drivers side rear door will not open from the inside or outside

I had exact problem Santa Fe 2007 2008 lock was stuck in locked position and door would not open from inside or out. All other doors would unlock with auto key remote. Carefully work the inside lock towards the open position as you lock and unlock the door with the remote. As you press unlock try to assist the lock to open. I did this a few times and the lock became free to the open position and all worked perfectly after this.
0helpful
1answer

1998 sienna driver side sliding door lock sticking

You can take off the interior panel and fix it there: https://www.youtube.com/watch?v=MkC2OiOiE_U
0helpful
1answer

My rear door on the passenger side is stuck so I can't open it from the outside. but today when I had the door open to ***** the problem my little brother flipped the button and turned on the child lock....

It sounds like the plastic connecting bit that links the outside door lever to the rod, that operates the door mechanism, has broken or become disconnected. To check, you will need to remove the trim on the inside of the door, after removing any screws and the inside door lever. However now that the child safety lock has been set it could be very difficult to get the door open.
All I can suggest is that you look at the other rear door to locate the position of the safety tab and then try to disengage it by using a suitable thin blade or something on your bad door so that you can again use the inside lever.
Once you have the inside trim off and the plastic sheet, you will see an access hole for the door mechanism and the outside operating handle of the door. It should be attached to the actuating rod by the aforementioned plastic bit. If plastic bit appears OK try re-attaching it or replacing it if broken. If the part of the handle which attaches to the rod is broken, the handle will need replacing.
0helpful
1answer

The interior door handle on the driver's side of my 2000 Tundra does not open the door. The exterior door handle works fine. I would assume the cable has broken on the door latch portion. What is the...

remove the screws that fasten the interior door panel to the door.  Visually inspect the handle assembly. there will be two cables that connect the handle and lock button to the door lock assembly.  I would bet that the L-shaped end of the interior door handle cable broke.  The replacement is self explanatory for the handle. Google the door lock assembly which isn't as visable.  Bob
0helpful
1answer

1997 Toyota Rav4 doors are locked

over time the grease in the locks etc can become frozen and stop movement when its warmed up a bit it will move better, using the key on the doors every now and then helps move this greas about as the central locking wont move these parts only the switches, replacing the grease after a degreasing locking mechanisms inside the door on the rear of the lock should help choose a grease that can handle low temperatures.
0helpful
1answer

Driver's door lock will not open by key or electronic fob

I was able to determine if you move the inside door handle toward the front of the car, then you could remove the door panel. However, it takes a little force to pot out the plastic clips, but if you work around the outside by appling pressure with a thin tool, such as a putty knife it will pot out.

My problem was a small yellow plastic part that connects the outside and inside door handle rods was broken.

So I plan to replace the part and see if that fixes the provlem. If so I can save over $340 dealer repair costs.
2helpful
1answer

Passenger door lock jammed

Your door latch assembly may be compromised. It could be rusted, the electric solenoid (if it has one) may be seized. Or the rods from the key are bent. Are you using th key in this door regularly? If not, the tumblers in the lock may be seized. Spray some WD-40 in the lock where the key goes, and jam the key in & out repeatedly, and retry. Remove the door panel & spray the interior of the latch, also. Hope this works for you; or, you are going to need new latches.
0helpful
2answers

Doors won't open

Jakenju, I would bet that the rod from the outer door handle is either off at the handle or the door latch on the pass door. Mayhap exact same problem on rear door.
0helpful
1answer

Broken outside door handles (front left and right)on 1999 Corolla. How to remove the interior door panels to get access to the handle?

I have the same problem on a Toyota Tercel 1997. I am trying to remove the door panel with the door closed (I can not open the door because the door knob is stuck in the lock position). I think I will have to cut through the panel. Have you found something ? My e-mail is [email protected]
Not finding what you are looking for?

876 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...