DLS Car Audio & Video - Page 4 - Recent Questions, Troubleshooting & Support
MY AMPLIFIER DOESNT SWITCH ON BUT I CAN SEE THE RED LIGHTS
first check all the power connections verify every thing is hooked up correctly. check the fuses. and the amp has to have a separate wire called remote going to the back of the head unit. the head unit sends a signal to the amp to tell it to turn on when the head unit is powered on.
How restart my pioneer WMA/Mp3 stereo
if there is a Reset button at the front face of the Radio, or else full restart can only be done by removing the battery terminal. but make sure you still keeping the Code, may ask for Code if it is Code protected.
How to set digital clock
on
Turn the radio on.
Hold down the volume knob for 3 seconds.
The display will come up Volume Setting
Rotate the volume know clockwise until the display switches to time setting.
Push the volume knob.
Rotate the volume knob to select the hour
Push the knob
Rotate the volume knob to select the minute.
Push the knob.
Done.
E01 code on my cd player in car
The vehicle has not been identified. The error message seems to appear on cd players when the tray refuses to eject. Lubrication of the ejection mechanism might help. Too little information has been provided to identify the specific model for any sort of disassembly. It is otherwise likely the player will have to be replaced.
Nissan micra audio locked says wait 1 hour
It is saying WAIT 1 HR because the wrong code is being entered.
Leave it SWITCHED ON for an hour and it will reset itself
Make sure you have the correct code
read below if you do not have the code
-----------------------------------------------------------------------------------------------
First make sure that the code has not been noted somewhere
within the car (underneath the ash tray, glove box , rear of sun visor etc)
To see if your code is available here for free then the radio will have to be
removed from the dashboard (and if you are lucky, someone may have written the
code on the casing ) .
If not then POST A BRAND NEW QUESTION
quoting the radio MAKE+MODEL plus ALL the LETTERS+NUMBERS on
ANY LABELS ,BARCODES or STAMPED IN THE METAL CASING
Also quote the MAKE of CAR
note: Unfortunately not all radios can be decoded using the
Serial Number
Otherwise try your Main Dealer ...........or take it into a
Decode Service who will plug in a laptop to read/recode the memory chip
(EEPROM). This takes a few minutes and shouldn`t be too expensive
Color code for factory wiring harness for 05 Hyundai Elantra
I found a wiring diagram for the 2005 Hyundai Elantra that might be helpful . According to the diagram, the color codes for the factory wiring harness are as follows:
Wire Color Function
Orange/Black 12V Constant
Yellow 12V Accessory
Black Ground
Blue/Black Power Antenna
Green/Orange Illumination
Brown/White Left Front Speaker (+)
Black/White Left Front Speaker (-)
Brown/Yellow Right Front Speaker (+)
Black/Yellow Right Front Speaker (-)
Brown/Red Left Rear Speaker (+)
Black/Red Left Rear Speaker (-)
Brown/White Right Rear Speaker (+)
Black/White Right Rear Speaker (-)
If you don't have a plug on your factory wiring harness, you can hardwire it by connecting each wire to its corresponding wire on your new stereo. You can use crimp caps or soldering to make the connections
. If you're not comfortable with hardwiring, you may want to consider purchasing an aftermarket wiring harness that clips onto the factory harness you removed off the rear of your factory radio during its removal. This will make it easier to connect your new stereo to your car's electrical system .
Hyundai Radio Wiring Color Codes - Radio Codes Calculator
Becker Grand Prix BE1432,
Not so. Becker radios are German products that are put into Mercedes (and other German imports). There are techs who advertise online and provide codes for a nominal fee. Worst case, you can contact BeckerUSA for a code for a bit higher-than-nominal fee.
Pontiac. Nice try.
Not finding what you are looking for?