be a blown thermistor or lamp. Remove fuser assy & check continuity on thermistor & lamps. Lamps must be disconnected to test. Error will have to be reset in service mode after replacing bad component
...test will be finished your copier dous not started, u must push the buttom wich is on ander the back cover in to the right and down place near the controller of DC. Than u push it, u can starting the ...
...the heater lamp,thermistor and thernofuse continuity. hello this is a fuser code. you will need to have a repair person come out to inspect the fuser. test the thermistor replace fuse. test
thermistor and the PWB. Use TC 14 to clear the self diagnostic display. To enter the serviceman test command mode, press the keys as follows: [#] key → [*] key → [C] key →
...thermistor disconnected or defective power supply not within rated range (15% or more below rating). Try cleaning or replacing the thermistors and reset code in service mode. you have an over heat ...
...test to see what it could be. I've done repairs previously and fixed the machine. This one is new. Mark You only change the thermistors???? What about the hot roller???? If there is crusted toner in ...
...thermistor,what i have to do? switch hold down 08 while holding 08 down swich on machine wait until test mode starts on the number pad put in 400 and press start input 0 and set switch off wait 30 ...
...the fuser, insert the two new thermistors, re-assemble, reset the error code and test the copier machine repair. Also, ask the copier technicians to to do a copier cleaning maintenance while on
Question about AR-M160 Black and White Copier
...copier machine I can't enter to simulation mode to clear H2 problem the thermistor it's work , i tested it with tester , the resistor it decrease when it is heated. "Press # - ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions