Question about Toro& Electric String Trimmer
...Steve After the bolts have been removed from the head, tap all the way around the head with a rubber mallet, (http://www1.mscdirect.com/CGI/NNSRIT?PMPXNO=4760615&PMT4NO=65151144), where it ...
Question about Lawn Mower With Toro Power Tools
l have to prime the carburator, to start my lawn tractor, after starting it only runs for 10 seconds, i have a full tabk of gas. What is the problem? you may have a sticky float valve---you may me ...
Question about Lawn Mower With Toro Power Tools
We have Toro Lwa 100 Lawn Mower Model #26623. Power engaged, start mowing but lawn mower will not cut grass. You have to stop and let it rev up again to cut more grass. This 1991-92 model is equipped ...
Question about Lawn Mower With Toro Power Tools
I HAVE A TORO WHEEL HORSE MODEL 71223, I PUT A NEW DRIVE BELT ON, WHEN I PUSH THE CLUCTH IN THE MOWER WILL KEEP GOING WHILE IT IS STILL IN GEAR, I HAVE RECHECK EVERYTHING I DID, THE BELT IS STILL ...
...the laquer build-up in the float and needle jet passages. Be sure to remove all plastic and rubber parts before using the laquer thinner because it can dissolve the plastic parts and render ...
...the laquer build-up in the float and needle jet passages. Be sure to remove all plastic and rubber parts before using the laquer thinner because it can dissolve the plastic parts and render ...
...dissolve the laquer build-up in the float and needle jet passages.Be sure to remove all plastic and rubber parts before using the laquer thinner because it can dissolve the plastic parts and render ...
Question about Power Clear 621 ZE 21 163cc Single Stage Snow Blower E-Start
...rubber seat. the seat over time becomes sticky and sticks the needle up and in place blocking the main fuel entrance. you can pick up a rebuild kit from you local small engine shop. you will need the ...
Question about Power Clear Snowblower 418ZR - 38272
I think the float is stuck on My Toro snowthrower 38272 It's possible. Is it all green and sticky inside the bowl?
Question about Power Clear Snowblower 418ZR - 38272
becomes coated with highly conductive dust from the brushgear and the shaft and bearings become sticky with old grease/oil. Cleaning and lubricating isn't difficult and if successful it saves expense.
Usually answered in minutes!
370 Questions
122 Questions
62 Questions
64 Questions