Questions & Answers for: portable heater keep turning

...heater 110,000 btu forced air portable kerosene Plug it in and it just hums. Fan turns freely. try this, take off the top cover. plug in the heater and when the humming starts, rotate the fan sharply ...

fan runs backwards forces flame to blow back into heater instead when I first start it up it works fine. Then after I get cold and try to turn it back on it keeps blowing the flame backwards. cracked ...

...heater? hold down the pilot valve knob and turn the arrow to pilot position push down on red button to allow gas thru pilot tube hold down and light keep button held down for 1-2 mins while pilot is ...

keeps kicking off, have cleaned it and still does the same thing, seems to kick off real quick if turned up, sometimes it will run for 30sec if on lowest setting, could it be the thermistate? we have ...

...portable spas have a 5.5kw heater and sometimes they can't keep up especially if the ambient temperature is lower than the set water temp. Here in southern AZ, we have to run the jets and blower ...

Why does my comfort zone infrared heater shut off after I turn it on? What modes does it have? What is wrong with my Comfort Furnace heater if i have it turned off and it still keeps blowing ,Yet if i

...turning off I turn on the heater for less than a minute and it shuts off on its own. At first it would turn off completely and now it is just turning off and not heating the room. We cleaned the ...

...heater stays on, until the flame suddenly turns opaque blue, by itself and turns off within 5 seconds. I would start by replacing the thermocouple. It is suppose to keep the gas valve open when in ...

heater will keep switching back and forth,there is a clicking sound everytime this happens.The heater won't heat up and the fan won't cut in,any info would be appericated.... Sounds like a bad control

...portable heater Here are some general operating instructions for the Corona SX3 kerosene portable heater: Fill the heater tank with kerosene. Make sure the heater is placed on a flat and stable ...