...pool ( 1 1/2 lines ) on 220v hookup--does not build up full pressure--water surges & never fills trap up full. When I replace with a 1HP Starite maxiglas-everything works fine. I bought the Flotec ...
Question about Automatic Salt Water System for Above Ground Saltwater Pool
...pool pump is surging and won't stay primed??? the pump will pump the water for a few seconds and then loose prime. Is the intake suppose to be to the pump side or filter side first? i think its pump ...
Question about Pro Series 18" Above Ground Pool Sand Filter System with Pump
...pool pump, now when I plug the pump in, it starts but trips the breaker. Any suggestions? you could try taking starter solenoid apart and drying / cleaning it. Spray heaps of WD40 around and inside ...
pool when shut off power to pump turned off and there begines a surge of water in lines which causes a water plume in deep end of pool. Air bubbles in pool inlets and at clean out canister just before
...POOL PUMP MOTOR REPAIR GUY .. COST ABOUT 75.00 ... WATER DAMAGE VOIDS WARRANTY'S.....JAY Check the impeller to difuser clearance. If the clearance is too great or the impeller is wobbling, the water ...
Question about 1.5hp Max Flo Inground Pool Pump # Sp2810x15
replacing or lubricating the seal on the basket lid. Pool pumps rely on a completely sealed system to work properly. If there is any air getting into the system on the suction side the pump will surge
Question about 1 12 Hp Super Swimming Pool Pump Sp2610x15
PUMP COMES APART Fixed skimmers are good for small bodies of water that don't have a surge tank. Performance of fixed skimmers will change depending on the height of the water. Overflow gutters don't.
Question about 1 12 Hp Super Swimming Pool Pump Sp2610x15
...pool pump is surgeing after running for 10 min. I bought the jacuzzi pump n earth filter as 1 piece. Pump runs smooth n very quiet. runs for 10 min, then pump starts to surge n the water level in the ...
...pool. I clean the filter once a week. About a month ago, I turned the pump on and the water was a little low, the water would start to circulate and then stop. Could that have anything to do with it? ...
Question about Kreepy Krauly In-Ground Pool Cleaner
pool pump start surging when I connect the vacuum cause you are sucking air from the hose Pre-fill the hose with water. use a hose or pool water to fill it then connect and it shouldn't happen, unless
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions