Questions & Answers for: Husqvarna need for drift

...assy and the machine gives a broken thread indication shortly afterward, the pre-tension assy needs to be adjusted. If the machine has the original "snap in" tension assy that was in the first ...

...drift it will pop the fly wheel off. you may need a hand. if it wont come off use a screw driver under the fly wheel and pry it up when you strike the nut..Dont hit the nut /shaft without the soft ...

...type I use a drift to knock it LH. You also need a piston stop this will lock up the engine. This is basicaly a rod with the plug thread on it that stops the piston from going all the way to the

need to remove the clutch to get to the chain sprocket ,the side panle is all dismantled, will it just pull of the shaft or is there a locking grub srew ? please help malc The previous suggestion will

...need a steel drift or punch smaller than the axle. put it nearly through to the bearing on the other side and hit it at right angles to the bearing, this should move the inner spacer sideways and ...

My Husqvarna Emerald continuse to stitch after I release the foot pedal. Although the stitching is at a greatly reduced speed it won't stop unless I turn the machine off. It sounds like the food pedal

...a yth2146k. Ant suggestions on how to loosen? using a copper drift and a hammer place drift on nut or shaft and give it a good welt. maybe need a couple of belts if that fails you may need to use ...