hp designjet 1050 problem dear all, the problem is printer switch off, check printerhead type 2. thanks, boby Oiled the slider rods and ensure there was no debris or damage in the printhead path. You ...
...check printhead path error type 2 Something (not sure what) is obstructing the movement of the carriage assembly. Turn off the power and remove the cleaners. Push the carriage assembly out and ...
Question about DesignJet 1050c plus InkJet Printer
...Printer off,check printhead type path (2).The printer carriage head stops at the middle and displays the error. Machine name is Hp 1055cm plus plotter. it seems like there is no oil on the slide ...
check printhead path type 2", any suggestions. I have cleaned along the track but problem persists on power up. Head alignment begins and after a short while the error message is displayed there is an
...Check the condition of the carriage belt. If there are rubber crumbs under the belt, replace the belt. Clean the encoder strip with a soft cloth and warm water. Use canned air to blow out the encoder ...
Question about DesignJet 1050c InkJet Printer
...Check Print Head Path Type 2 when trying to plot to our designjet 1050C. The carriage makes a slight clicking noise on the left side of the rod. Does anyone have a fix for this? Thanks Upon power up, ...
HP 1050C Designjet I am getting the error 'Check printhead path Type 2. Then it says to switch off. Hello. The "Check Print Head Path" error is usually a worn out carriage belt on printers more than 5
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions