Questions & Answers for: hoover pe235 washing machine

Hoover PE235 Just installed my PE235 again (been sitting in garage for a year), however when I started it first time i hadnt turned the water taps back on... Now the machine doesnt fill up? When i put

hoover pe235 is there anyone who could post a picture of the control dial as all the print has dissolved off mine from stain remover. Contact Hoover, they should be able to supply you with a new dial ...

...hoover washing machine won't take the fabric conditioner, it's about 18 months old. I've checked the pipes at the back i.e cold water inlet valve turned on fully and waste pipe not kinked or trapped. ...

hoover performer washing machine,on the dial it has the wash settings in numbers but theres no details on the front to tell you which eash is what.does anyone have this imformation please?i need to do

washing machine wont spin My washing machine wont spin or empty please help!!!!!! Check the filter and pump are clear of any objects. ie hair clips etc.

[email protected] hover pe235 goes through cycle tnen stops before spin cycle, and won't empty the water Sounds like you have a blockage in the filter or the motor brushes have worn down. Adrian

PE235 would not spin or empty. Now it wont cycle either I have removed the pipes from the filter and found a plastic badge lodged in the pipe. Ive move this but now it wont seem to follow any cycle at

not spinning clothes come out wet hello make sure spin hold button is not press in if there is 1 on this machine any other spin problems can be caused by module board this is at the back of the washer

...WHERE IS IT ? Hello, Unplug the washing machine and turn off the water. Open the small trap door next to the drain hose connection on the back of the washer to gain access to the filter. Good ...

...to gain access to the filter. Good luck. There is a full diagram and explanation here: http://www.fixya.com/support/p41626-hoover_pe235_front_load_washer/manual-18058/page-25 please rate my ...